Laserfiche WebLink
Load (with chamber liners, approximately 4 minutes/chamber) <br />• Place chamber liner on chamber <br />• Fold Chamber liner back over load door; place clamp ring over folded liner. <br />• Load chamber, remove clamp ring, and tie/secure the liner. <br />• Rotate chamber into the sterilization position. <br />2. Sterilization <br />• Blue "Sterilize" button is activated. <br />• San -I -Pak first pulls a vacuum with a minimum of 18 inches within the chamber. <br />• Air removes during the vacuum stage is mixed with 307° F. steam. <br />• Steam is then injected into the sterilization chamber; chamber reaches a maximum of 38 psig. <br />• After a temperature of 270° F. is achieved; a 30 -minute timer is automatically activated. <br />• Chamber quickly reaches an ultimate temperature of 281 ° F. — 284° F. <br />• Chamber is held in a high temperature, high-pressure environment for the full 30 minutes. <br />• Upon completion of the sterilization cycle the chamber vents down. <br />• Existing steam is piped to the condensate tank; it condenses and flows into the sanitary sewer. <br />3. Discharge <br />• Open load door. <br />• Activate "Dump" button. <br />• Sterilized waste falls into discharge cart. <br />• Return to load position. <br />4. Tubs <br />• Once filled, the tub is moved to the cart dumper/compactor. <br />5. Compaction <br />• Activate cart dump/compactor button. <br />Most operations of a San -I -Pak System require a minimum operator interface. Operators are <br />needed to load the unit, (cart dumping systems are available), close the sterilization chamber <br />door, and to open the sterilization chamber door. Besides pressing a few buttons, no other <br />operator interaction is required. <br />Monitoring <br />Each autoclave is equipped with recording devices, which automatically and continuously monitor <br />and record performance and process parameters throughout the autoclave cycle. The autoclave's <br />programmable logic controller is programmed to achieve the prescribed time, temperature and the <br />process is reinitiated through another complete cycle. Through the telecommunication system, San - <br />I -Pak, Inc. is also able to monitor the system from our factory upon your request. <br />Maintenance <br />