ARCHIVED REPORTS_2002_3 JTD - Laserfiche WebLink

Home Browse Search

creation of dust by spraying with water trucks and, when feasible, stockpiling and placing material in locations that are protected from the wind. Compostable Materials (off-spec, delivered by ;venerator): Compost materials are delivered directly to the working face and stockpiled to the side. If more material comes in than is required for the day, the material is stockpiled within the waste management unit and used, as needed. The compost material is spread evenly over the active face in a minimum compacted thickness of six inches and an average compacted thickness no greater than 12 inches using a dozer. Treated Auto Shredder Waste (TASW): TASW, that has been processed and treated in accordance with 22 CCR Section 66268.106(a)(1), is delivered directly to the working face and stockpiled to the side. If more material comes in than is required for the day, the material is stockpiled within the waste management unit and used, as needed. The TASW is evenly spread and compacted over the active face in a minimum 6-inch lift and average compacted thickness of less than 18-inches using a dozer. If major precipitation events are anticipated within several days, Forward will cease using TASW until the threat of precipitation is over in compliance with condition "r" of the SWFP. Construction and Demolition Wastes: C&D is delivered directly to the working face and stockpiled to the side. If more material comes in than is required for the day, the material is stockpiled within the waste management unit and used, as needed. Processed C&D waste materials will be ground, pulverized, shredded, screened, source separated, or otherwise processed alone or mixed with soil in a manner to provide a compacted material free of open voids when applied to meet the performance requirements as alternate daily cover. Processed C&D waste materials used as ADC shall be restricted to the following materials: rock, concrete, brick, sand, soil, ceramics, cured asphalt, lumber and wood, wood products, roofing material, plastic pipe, plant material when commingled from construction work, and fines derived from processing the above materials. These materials shall comply with a grain size specification by volume of 95 percent less than 12 inches and 50 percent less than 6 inches as determined by the LEA. The C&D wastes are evenly spread over the active face in a minimum 6-inch lift and average compacted lift thickness of less than 18-inches using a dozer. The Forward Landfill JTD 6-11 J:\Allied\Forward\JTD Amendment\January 2007 JTD Amendment\JTD Sec 6 Final.doc: 5/22/02;Rev. 1: 7/2002:Rev.2:4/2003;Rev 3:6/2003;Amendment No. 1:2/1/2007 BRYAN A.STIRRAT®ASSOCIATES