Laserfiche WebLink
February 18, 2010 <br />ATTN: <br />RE PROPOSED: <br />Dear Mr. Raja: <br />San Joaquin County <br />Environmental Health Department <br />600 East Main Street <br />Stockton, California 95202-3029 <br />Website: www.sjgov.org/ehd <br />Phone: (209) 468-3420 <br />Fax: (209) 464-0138 <br />KHURAM RAJA <br />BEBE MART <br />1169 SOUTH MAIN STREET <br />MANTECA, CA 95336 <br />BEBE MART <br />231 WEST TENTH STREET <br />TRACY, CA 95376 <br />DIRECTOR <br />Donna Heran, REHS <br />PROGRAM COORDINATORS <br />Robert McClellon, REHS <br />Jeff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />This letter indicates San Joaquin County Environmental Health Department (EHD) approval of <br />drawings submitted for the proposed BEBE MART, subject to the following condition(s): <br />1. Walls and ceilings of all rooms (except for bar areas, areas where food is stored in <br />unopened containers, dining areas, and offices) shall be of a durable, smooth, <br />nonabsorbent, and washable surface [CRFC §114271]. <br />2. All ice machines and bins, food preparation sinks, warewashing sinks (dishwashing <br />units), display cases and refrigeration units, and any other food service equipment which <br />discharges liquid waste, shall be drained by means of indirect waste pipes discharged <br />through an air gap into a floor sink or other approved waste receptor. All floor sinks are <br />to be positioned to be readily cleanable, accessible for inspections, and must be flush <br />with finished floor. Do not place floor sinks inside walk in refrigeration units or cabinets <br />[CRFC §114193 and §114193.1]. <br />3. All manufactured and custom-made food service equipment must be certified for <br />sanitation by an American National Standards Institute (ANSI) accredited certification <br />program. All proposed equipment is subject to EHD approval [CRFC §114130]. <br />4. The floor surfaces in all food preparation or packaging areas, open food storage areas, <br />utensil washing areas, refuse storage areas, janitorial areas, and all restroom and <br />employee change areas, shall be smooth and of durable construction and nonabsorbent <br />material which is easily cleaned. These floor surfaces shall be coved at the juncture at <br />the floor and wall with a three-eighths (3/8) inch minimum radius coving and shall extend <br />up the wall at least four (4) inches. Rubber or vinyl top set base is not permitted in <br />these areas [CRFC §114268]. <br />5. Hot water shall be supplied at a minimum temperature of at least 120°F measured from <br />the faucet. The water heater shall be a 10 gallon minimum capacity [CRFC §114192]. <br />