Laserfiche WebLink
Sock Instructions Page 2 of 8 <br /> 41 For the test, use a 5 foot section of pipe with an outside <br /> diameter 1/2 inch smaller than the source well's inside diameter. <br /> KEY REQUIREMENTS FOR INSTALLATION <br /> 6 SOCKS MUST BE INSTALLED WITII BLACK <br /> GROMMETS ON TOP <br /> Wrap Socks as independent units (see page 3, figure 5) <br /> A A maximum of 20 ea. 2-inch socks per section. <br /> 6, A maximum of 8 ea. 4-inch socks per section. <br /> 6 A maximum of 6 ea. 6-inch socks per section. <br /> 6 Make sure each sock is properly shaped (cylindrical and without <br /> bends) to facilitate ease of installation and removal. <br /> HELPFUL HINTS <br /> 6 ORC matrix hardens into a cement once hydrated <br /> 6 Minimize slack between each sock, by periodically pulling up <br /> slack while lacing <br /> 6 Tie off ORC retrieval lines to the well cap. Regenesis <br /> recommends the use of a 3/8" diameter x 6" long eyebolt. <br /> 41 The ORC Socks should be wetted to prevent excessive dusting <br /> prior to installation <br /> 41 Make sure your work area is clean to avoid oil and dirt deposits <br /> on the socks. <br /> http://www.regenesis.com/ORC/Instructions/SOCI(IIISII'ucliOlIS,htill 2/27/01 <br />