COMPLIANCE INFO_2018 - Laserfiche WebLink

Home Browse Search

DO NOT loosen the stainless steel retaining bands securing the bellows to the containment bucket top Testing Spill Containers ring or the containment bucket bottom. Loosening Use California Test Procedures. Their Test the retaining bands voids any and all warranties on Procedures will check the seals between the drain this product. valve, nipple and rotatable adapter. To test the spill containers base and bellows fill the container with Warning: water. A drop in the water level of 1/16" or greater if the cover is removed, for any reason, follow after one hour means that a leak exists. To the Service and Maintenance instruction as determine where the leak is, look for a steady noted. Always remove the existinq-gaskets and stream of bubbles coming from one of the joints or install new gaskets. Never reuse the old water leaking on the outside of the bucket. NOTE: _gaskets. Reuse of gaskets may result in an Do not drain the water into the UST after the test is improper seal. complete. Water must be disposed of per local requirements for hazardous waste. If the leak Operation and Maintenance: cannot be corrected the spill container should be After each fuel delivery, the operator must replaced with another. remove any standing fuel from the container. Fuel can be removed by actuating the drain POMECO recommends periodic inspection of covers valve or with a gasoline absorbing disposable and seals as a part of the regularly scheduled towel. Annually: Inspect and clean the interior maintenance program. If any of the seals are of the spill container and drain valve screen. damage they should be replace. Only qualified, Remove accumulated dirt and grit. If the drain competent, well-trained technicians should perform g maintenance. valve screen becomes clogged, remove the Note: Common sense and good judgment should valve, soak in water and use high-pressure air to always be exercised. The contractor's clean. Reinstall the drain valve to its proper position understanding of all related site conditions prior to and test the valve per the appropriate California Test starting the project is essential. If the contractor Procedure. If problems persist, replace the drain does not have a clear understanding of the required valve with P/N 1 DK-2100-EVR (specified torque work and site conditions, the contractor is advised to 11.5 ft-lbs min to 13.5 ft-lbs max, 5/16-18 UN seek clarification prior to starting any portion of the thread). The sealable cover (1 SC) adjustment project. nut is set at the factory, but due to environmental conditions it may be necessary to adjust it to either improve sealing or ease cover removal. Important: Leave these instructions with Station Operator as per CARB Requirements R E ,2FIV D UCT 1 1 2018 C30 F3, - ENVIRONMENTAL HEALTH A P DOVER cOMPAMv DEPARTMENT P.O. Box 405003* Cincinnati, Ohio 45240-5003 1-800-422-2525 Domestically 513-870-3315 Internationally Marketing Agent for POMECO by OPW, Inc. Copyright, 2002 -OPW Fueling Components Inc., Cincinnati, OH Printed in U.S.A. p/n H14976PA—09/02 POMECO Multi port Spill Container Page 4