COMPLIANCE INFO_2018 - Laserfiche WebLink

Home Browse Search

13. Using the 61 SA-TOOL, tighten the spill 19. Apply an even bead of PISCES SL-1100 around container(s) onto the riser(s)with a minimum the 5/16" hex bolts after final tightening. torque of 125 ft.-Ibs. and a maximum torque of 20. Install the spill bucket covers. (See Figure 6.) 250 ft.-lbs. 14. The bolt holes in the multi-port cover must line 21. (Optional): Install the product identification disc up with the bolt holes in the containment bucket on the spill bucket cover and multi-port cover in mounting ring. the I.D. disc recess. 15. Maintenance or as needed: Apply an even bead 22. Cover the multi-port perimeter ring and cover of PISCES SL-1100 onto the bottom of the with plastic to prevent concrete from settling in mounting ring before assembling the the drainage areas. containment bucket mounting ring and the 23. It is required that the perimeter ring and skirt mounting ring onto the multi-port cover. (See assembly, and the multi-port cover be set as an Figure 5.) assembled unit, with the bolts engaged. Failure to engage the bolts may result in the distortion of Bolt Beveled Washer the ring and improper fit of the ring to cover after evel Facing Down) the concrete is poured. Mounting Ring i' Z"_>Thread Seal Washer 24. When pouring the concrete, hand shovel or trowel the concrete around the multi-port 1SCES SL-1100 assembly to prevent the unit from moving or shifting, which can cause alignment problems i` and future maintenance problems. T �..!' 'ontainment Bucket Note: Do not stand on the multi-port before the Y' Mounting Ring concrete has set up. 25. It is recommended that the paved contours around POMECO covers be adequately sloped Figure 5 to direct water flow away from the cover, and directing water runoff from adjacent areas away from POMECO covers. (See Figure 7.) 16. Install the beveled thread seal flat washer and the thread seal washer onto the bolts for the mounting ring. (See Figure 5.) Note: Install the beveled thread seal flat washer + �y' .>> on the bolt with the beveled surface away from the bolt head. Install the thread seal washer to seat between the flat washer and the mounting ring. 17. Apply PISCES SL-1100 to each bolt prior to inserting them into the mounting ring. 18. Tighten the mounting ring retaining bolts until the containment bucket gasket makes contact with the multi-port cover. Then, in a crossing Figure 7 pattern, torque the bolts down between 15 to 20 ft.-Ibs. 26. Remove the plastic after the concrete has set up. 27. After installation is complete, water test the O O multi-port fixture. The recommended water test procedures include: a) Spraying water on cover(s)for 5 to 10 minutes, using a commonly available 0 0 watering device such as a lawn sprinkler. b) Standing water test, not to exceed 1/2" in water depth for a period of 5 to 10 minutes. Note: The containment bucket consists of three components steel top ring, bellows, and bucket bottom. These parts are held together with stainless steel retaining bands. Figure 6 POMECO Multi port Spill Container Page 3