Laserfiche WebLink
' = = Lo ' <br /> �ONMENTA SALT <br /> B = 18 = 3 Compfd �Ni <br /> n PRODUCT- <br /> B - 18 - 3 orientation <br /> The brass secondary line test plug located <br /> within the body should be at a 90 ° degree <br /> angle from any flat wall . If it is at any other <br /> angle , the fitting is not installed correctly <br /> IF mw� 0 <br /> and /or the gasket is not flat against the floor. <br /> UPPER Whether the gasket is seated firmly to the floor <br /> or not , or if the orientation is incorrect , the <br /> Vulkem sealing method outlined below is the <br /> ad 6 <br /> best way to make a lasting liquid -tight seal . <br /> When pressure -testing the secondary : the <br /> top nut makes this seal . The Brass plug should <br /> not be removed . If leaks occur from the top <br /> BRASS PLUG nut/donut then loosen them with WD40 if <br /> necessary and re -seat with wet- dry grease . <br /> Then tighten the nut no more than 1 /4 - 1 /2 <br /> turns past hand tight . <br /> B - 18 - 3 Vulkem Seal <br /> WARN I N G I The lower nut of the <br /> B - 18 -3 fitting must not be loosened without the <br /> compression donut securely sealed against <br /> the pipe . The uper nut holds the donut secure . <br /> If both are loosened too much the 13 - 18-3 <br /> fitting body may drop down or fall through the <br /> bottom of the shallow pan . <br /> UPPER NUT After cleaning all contact areas thoroughly, use <br /> vulkem to seal between the bottom nut and flat <br /> LOWER NUT Moil, gasket . With the top nut secured to the pipe , <br /> loosen the lower nut and apply vulkem under <br /> the nut and generously to the exposed threads <br /> of the body. Do not dislodge the flat gasket or <br /> apply vulkem between it and the floor of the <br /> i FLAT DASKET shallow. Lubrication can cause it to slip loose <br /> VULKEM <br /> or pinch once tightened causing a leak point . <br /> 3 H -132000 - RETROFIT- KIT- 14A <br />