INSTALL_2020 - Laserfiche WebLink

Home Browse Search

S A N J O A Q u I N Environmental Health Department -- COUNTY- 6 . A valid California Department of Tax and Fee Administration (CDTFA) number must be obtained and provided to EHD prior to fuel drop, and must be uploaded into CERS . 7. The following items must be completed prior to scheduling the final inspection : a . An accurate and drawn to scale as-built drawing, which indicates the location of the UST system (underground storage tanks, piping , auxiliary and monitoring equipment) with respect to buildings or other landmarks, per CCR 2711 (a)(8), must be submitted to EHD . b. Copies of any required installation checklists (tank, etc.) must be submitted to EHD. c. The designated operator (DO) training requirement must be satisfied , per CCR 2715(f) . d . Submit to the California Environmental Reporting System (CERS) all applicable hazardous materials, hazardous waste, and UST submittals. The submittal must be approved by EHD. 8. The installed UST system must be compliant with all applicable laws, regulations, and industry standards. All installation and testing shall be in compliance with manufacturer's instructions and CCR 2635 and 2636 . All monitoring system components shall be listed in the State Water Resources Control Board's Local Guidance Letter (LG) 113 . 9. All primary containment including any integral secondary containment system must be certified by an independent testing organization and labeled as required by the organization (California Code of Regulations Title 23 Chapter 16 (CCR) 2631 (b) ; UL , ULC , ANSI , API , ASTM , etc. See CCR Table B for complete list. ) . Pursuant to Underwriters Laboratories Inc. ( UL) listing requirements, only those products bearing the UL mark will be considered listed . ANY PART/PRODUCT NOT MARKED WITH THE UL LABEL OR ANOTHER LISTED TESTING ORGANIZATION WILL BE REJECTED. All secondary containment system which is not an integral part of the primary containment shall be designed and constructed according to an engineering specification approved by a state registered professional engineer or according to a nationally recognized industry code or engineering standard , per CCR 2631 (d). 10. All metal components in direct contact with the ground , such as flexible connectors, swing joints, fittings, clamps, bands, and pumps , shall have adequate corrosion protection . 11 . Install concrete of sufficient thickness over USTs and around sumps and dispensers , according to the manufacturer's written installation instructions and buoyancy calculations. 12 . All tank top openings that are connected to the primary space of the UST must have secondary containment, audible/visual alarm , and be vapor tight or terminate at grade. 13. Sumps, including UDCs, must be constructed in a manner to prevent vapors from entering the backfill. 14. All secondary containment must be constructed to prevent water intrusion and must be continuously monitored as required under HSC 25290. 1 . 15 . Chase piping must be VPH monitored and included in its respective product piping vacuum monitoring zone. All vacuum zone volumes must be accurately programmed and their volumes adequate for their respective vacuum sensors . All sensors must be installed to detect a leak at the earliest opportunity. 16. All appropriate test ports must be installed to facilitate frequent routine communication testing (e.gl at the beginning and end of each vacuum zone branch and inside brine filled sumps) . No additional shut off valves should be installed between the monitored interstitial spaces and their respective sensors. 17. Overfill prevention shall satisfy CCR 2635(b)(2)(C) , pursuant to the permit application . No ball floats shall be installed on vent lines to comply with overfill prevention requirements (Code of Federal Regulations, Title 40, section 280 . 20(c)) 3 of