COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

Installation G de: Heswnfi mvanTa�4 stems For complete control panel installation instructions, see the installation manual for the electrical control panel that comes with your system. These instructions ship with the control panel and hang from a clip on the inside of the panel door.* Step 8a: Make sure the instructions and the items supplied conform to state and local regulations. Step 8b: A qualified and licensed electrician should install and service the panel and ancillary wiring in compliance with the National Electrical Code, as well as state and local codes. (Wiring diagrams can be found in the installation manual* that comes with the panel.)Wiring will include the following items: a) Incoming power to the panel. There may be one or more circuits required, depending upon the number of pumps and local electrical codes. b) Wiring from the control panel to the pump and floats. c) Wiring to a discharge pump and floats (if applicable). NOTE. While we do not recommend installing a control panel against the wall of a bedmom, living mom, or other living space, you could mount it on a 4 X 4 post adjacent to such a wall. - '-^..: #4 -rTrtis � Step 9a: Determine which end of the pod you are installing the transport line into and cut a 1-314"hole in the pod where itis marked with a cross.Remove any burrs and install the Air Genf 1-114" grommet, sealing it in place with ADH100 adhesive. 4:. NOTE. The transport line can be connected to either end of = the AdvanTex pod.Installing it in the end QWosite the discharge line—on the.same side.as the passive air vent---will facilitate cleaning.In some cold weather installations, however, it may be desirable to install the inlet on the same end as the outlet. Step 9b: From the inside of the pod, insert the lower manifold ' elbow through the grommeted hole, and connect the 1"transport line from the discharge assembly to this elbow. In cold weather installations, it is a good idea to slope the line so that it drains back to the tank after every cycle. ' Step 9c: Temporarily disassemble the manifold union so that, when the pump first comes on during start-up, any debris in the transport piping will not be pumped into the manifold(which could then require orifice cleaning). * If the instructions are missing or have been removed from the door pouch inside the control panel, call Orenco for a replacement or down- load a copy of the instructions from our online Document Library at www.orenco.com. 0 2204 Orenco Systems*Inc. NIM-AMA%-11 par M.041114