COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

InstaIIat om Cohle: &gidentiai AdvanTj � Systems /e� �f •��,; .:a�cr7^'„�k �k!5.:;�'.3�,Y.�'I,.�., Follow the generic steps on this page and the panel-specific (VenCommo or MVP) steps on the next few pages to ensure the system is operational. Step 1: For Mode B installations, fill the pump basin with water to a level just below the lowest float. Step 2: Verify both manual and automatic operation of the recirculation pump.Before running the pump, ensure that the tank's water level is at least 4" above the bottom float,but below the top float. Be sure that you have temporarily disconnected the manifold union.Flip the MOA toggle switch in the control panel to"Manual"to test manual operation of the pump and clear any debris in the transport piping. Step 3: Reconnect and hand-tighten the manifold union. With the pump running in the manual position, open each lateral ball valve individually for 5 or 10 seconds to flush any construction debris out of the piping. Be sure all lateral valves are completely closed after flushing is complete.With the pump still running manually,remove several orifice shields and measure the squirt ylo. f height with a tape measure. The squirt height should measure approximately 3'-5'. Windy conditions will cause the squirt heights to measure less. Step 4: For more accurate residual measurements,attach a piece of clear PVC to'the end of the lateral.Record the residual head measurement at start-up and before and after servicing. Step 5: Return the MOA switch to"Automatic."To facilitate quick testing of the automatic operation,temporarily set the programmable timer to short intervals,but no shorter than 15 seconds on, 15 seconds off. Step 6: Fill the tank with clean water up to a level approximately one inch above the RSV cage.At this point the water level should be well above the bottom float. In the control panel,turn on the pump by switching the MOA toggle to the "Manual"position.As water begins running through the system, ensure proper drainage through the filtrate return line and RSV. All or some of the return filtrate flowing to the RSV should be exiting the system through the final discharge line. Check that no water is leaking at any of the plumbing joints. 0 2004 Orneao Systems*Inc. HIM-M-AX-1 Rey 3.1,004