Laserfiche WebLink
In-N-Out Burgers NGF 255 Progate Drive Thru Installation Manual <br />© 2011, IMI Cornelius Inc.- 7 -Publication Number: 621058475INS <br />NOTE: Refer to Water Installation section or Decal on the lower front of the unit for the location of <br />syrup and water connections. <br />5. Clean the hopper interior. <br />6. Connect the unit power cord to a 120 volt, 60 cycle, 3–wire grounded receptacle. For 220-240 Volt International <br />Units, a 3-wire power cord is provided. An adapter plug for the particular country will need to be provided by <br />the Installer. <br />ADJUST CARBONATOR CO2 R EGULATOR AND TURN WATER INLET SUPPLY LINE ON <br />1. Open (counterclockwise) CO2 cylinder valve slightly to allow lines to slowly fill with gas, then open the valve <br />fully to back-seat the valve. (Back-seating the valve prevents leakage around the valve shaft). <br />2. The carbonator CO2 regulator is fixed at a nominal 75 psi. <br />3. Open one of the post-mix dispensing valves to exhaust trapped air inside the carbonator tank. <br />4. Open the water inlet supply line shutoff valve. <br />CO2 INSTALLATION <br />WARNING: Machine is designed to work only with CO2. Store air supplied from a compressed air system could <br />contain moisture and oils that could damage and/or cause the Ice Gate to loose performance or malfunction. <br />1. Use 1/4” tubing capable of handling a minimum of 120 psi. <br />2. Guide CO2 lines from back of machine to front. <br />3. Locate CO2 line and connect to the barb fitting. <br />4. Use Oetiker clamps to secure all lines to barbed fittings. <br />5. Replace lower splash panel to frame. <br />Figure 4. <br />PROGATE CO SHUTOFF2 CARBONATOR FEED <br />CO INPUT2