Laserfiche WebLink
22 <br />LOADING THE CONCENTRATE <br />1. Thoroughly mix concentrate by vigorously shaking the product Bag-In-Box (BIB). <br />2. Pull the BIB connector through the hole provided in the box and place it on the drip tray with the connector <br />facing up. (See Fig. 1) <br />3. Open the dispenser door and locate the appropriate left or right BIB Adapter fitting. <br />4. Pull the Adapter fitting down and connect it to the BIB. (See Fig. 2) <br />5. Place the BIB upright in the machine, rotating it into position with the connector facing forward. <br />6. Rotate the BIB Adapter to avoid sharp bends in the tubing and allow it to be routed between the two <br />pumps. <br />Refer to the Tube Installation Decal on the door for proper routing. (See Fig. 3) <br />7. Close the cabinet door. <br />PRIMING THE CONCENTRATE LINES <br />1. Open the dispenser door. <br />2. Load concentrate per instructions in the section titled Loading the Concentrate. <br />3. Select Prime on the Function Selector Switch and Run on the Mode Selector Switch. <br />4. Close the dispenser door. <br />5. Place a container under the appropriate dispense tip. <br />6. Activate the appropriate dispenser until concentrate flows from the dispense nozzle. Priming may take 5 to <br />10 seconds. <br />7. Open the dispenser door, select Normal on the Function Selector Switch, and then close door. <br />Note: Concentrate may continue to drip out of dispense tip. The user may wish to run a Rinse Cycle (refer to <br />Rinsing) after Priming the dispenser to clean out the remaining concentrate. <br />Fig. 1 Fig. 2 Fig. 3 <br />7 3 3 <br />36026.1 010313 <br />RELEASED FOR PRODUCTION <br />DIR Num: 36026.0001 19, May 2015