Laserfiche WebLink
21 <br />INITIAL FILL & HEAT <br />1. Select Normal on the Function Selector Switch and Run on the Mode Selector Switch. <br />2. Confirm the water supply is on. <br />3. Connect the dispenser to the power source. The Red POWER LED will illuminate and water will begin flowing <br />into the tank. The dispenser will automatically stop filling when the tank is full. The dispenser will not begin <br />heating the water until after the tank is filled. Dispenser models with product chillers will begin to cool the <br />cabinet at this time. <br />4. The Green READY LED will illuminate when the tank temperature reaches the preset ready temperature. <br />Note: The time required to heat the water initially will vary depending on the AC Power supplied to the <br />dispenser. <br />While the tank is heating, the dispenser may be readied for use as described in Programming Functions & Basic <br />Operations. <br />3 <br />4 <br />1 1 <br />36026.1 010313 <br />RELEASED FOR PRODUCTION <br />DIR Num: 36026.0001 19, May 2015