Laserfiche WebLink
28 <br />Activate the Dispenser within 5 sec. to <br />dispense the pre-selected volume. <br />Front Panel LED Display Messages <br />Alternate Portion Dispenser <br />Volume #2 has been selected <br />Portion LED “ON” <br />Portion Dispense <br />Enabled <br />Rinse Dispenser, see Rinse ProcedureDispenser Locked Out <br />Rinse Cycle Required <br />Rinse LED “FLASHING” <br />Rinse Lockout Enabled <br />Rinse Dispenser, see Rinse ProcedureRinse Cycle RequiredRinse LED “ON” <br />Rinse Timer <br />Check Tank Temp Setting <br />Check Ready Temp. Setting <br />Service Required: Change the Supply Voltage, <br />see Optional Field Wiring <br />Usage has exceeded the <br />capacity of the Tank Heater <br />Ready LED “OFF” <br />Water Temp. Too Low <br />Check Power Cord <br />Check the AC Power Circuit Breaker <br />Service Required <br />Dispenser Not plugged in. <br />AC Circuit Breaker OFF <br /> Power LED “OFF” <br />No AC Power <br />Troubleshooting <br />A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems <br />encountered. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic <br />Technical Service Department. <br />• Only qualified service personnel should perform inspection, testing, and repair of electrical equipment. <br />• Shorting the terminals or the application of external voltages to electronic components may result in component <br />or circuit board failure. <br />• Intermittent operation of electronic circuit boards is unlikely. board failure will normally be permanent. If an <br />intermittent condition is encountered, the cause will likely be a switch contact or a loose wire connection at <br />a terminal or crimp. <br />• Solenoid removal requires interrupting the water supply to the valve. Damage may result if solenoids are <br />energized for more than ten minutes without a supply of water. <br />• The use of two wrenches is recommended whenever plumbing fittings are tightened or loosened. This will <br />help avoid twists and kinks in the tubing. <br />• Make certain that all plumbing connections are sealed and all electrical connections are tight and isolated. <br />• This dispenser is heated at all times. Keep away from combustibles. <br />WARNING: <br />• Exercise extreme caution when servicing electrical equipment. <br />• Disconnect the brewer from the power source when servicing, except when electrical tests are specified. The <br />red “Power LED” on the door indicates that the unit is connected to AC Power. <br />• Follow recommended service procedures. <br />• Replace all protective shields or safety notices. <br />36026.1 010313 <br />RELEASED FOR PRODUCTION <br />DIR Num: 36026.0001 19, May 2015