Laserfiche WebLink
27 <br />DRAINING THE HOT WATER TANK <br />CAUTION: The dispenser must be disconnected from the power source throughout these steps. <br />1. Disconnect the dispenser from the power source. <br />2. Shut off and disconnect the incoming water supply. <br />3. Remove the front splash panel. <br />4. Pull out drain tube to empty into a sink or a container with a minimum of five-gallon capacity. <br />5. Make sure drain clamp is closed. Then, remove drain plug. <br />6. Direct tube into sink or container and open drain clamp. Continue draining tank until ALL of the water is out. <br />Be very careful with the draining water because it can be very hot. <br />7. Close drain clamp, insert drain plug, place drain tube back into machine, and replace splash panel. <br />Note: The dispenser must be refilled using the Initial Fill & Heat steps before reconnecting the power source. <br />36026.1 010313 <br />RELEASED FOR PRODUCTION <br />DIR Num: 36026.0001 19, May 2015