Laserfiche WebLink
Sensor Sensitivity Adjustment <br /> <br />1. Start with the sensitivity at minimum by turning the potentiometer to full counter <br />clockwise position. <br />2. Select target object with the least reflective surface. <br />3. Place target object in front of sensor. When object is detected a red light on the back of <br />the sensor will go on. <br />4. Increase the sensitivity by turning the potentiometer clockwise until the target object is <br />detected and the output status changes. <br /> <br /> <br />MAINTENANCE <br />Note. Disconnect power before cleaning! <br />• Remove the outer housing by removing the two hex bolts, then using the two handles <br />on the side of the outer housing; pull up until outer housing comes off the carriage <br />frame. <br />• Once outer housing has been removed proceed to remove front panel. Clean stainless <br />steel with soap water using a soft, clean cloth periodically as required. Clean the inside <br />of the unit at least once a month. Never use harsh abrasive, use only non-abrasive <br />scouring pads when required. <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br />