Laserfiche WebLink
Setup and Test <br /> Setting Overfill Alarm Horn Delay Time <br /> 1. Loosen the four screws that secure the Overfill Alarm cover clamps to the case. Slide the clamps away from the <br /> retaining lip on the door. Open the door. <br /> 2. Locate the I lour Time Delay Relay(see Figure 3). <br /> 3. Adjust the time the horn remains On from 0 to 60 seconds by turning the knob on the relay to the desired setting. <br /> a. Close the door anal t i,l tcn the four cover,, c\\ <br /> Testing the Overfill Alarm with the Acknowledgement Switch <br /> Turn On power to the Overfill Alarm and Acknowledgement Switch.Depress and hold in the TEST Button on the right <br /> side of the switch.The Overfill ,Vann horn will sound immediately,and the Overfill Alarm's red light will start flashing. <br /> The horn will turn Off at the preset delay time you set above(0-60 seconds).The red li ght will continue to flash until the <br /> TEST button is released. <br /> Setting the Overfill Alarm Horn's Volume Level <br /> 1. Locate the adjustment setscrew(1/16 1 lex wrench)on the exterior of the Overfill Alarm's horn cover(see Figure 1 <br /> on page 3). <br /> 2. Tum the adjustment screw counterclockwise to increase the dB level of the horn or clockwise to decrease its dB <br /> level. <br /> Testing the Overfill Alarm with the Console <br /> 1. With the Overfill Alarm and Acknowledgement Switch(if installed)connected to the console,consult the setup <br /> instructions for your console and perform the Output Relay setup procedure to recognize the Overfill Alarm. <br /> 2 Turn power Off to the console and the Overfill Alarni.Put a jumper between the two Overfill Alann relay <br /> connections in the console. <br /> OVERFILL ALARM W/O ACKNOWLEDGEMENT SWITCH <br /> 1. Reapply power.If the Overfill Alann is wired properly,the alarm horn should sound immediately followed by the red <br /> alarm light flashing. <br /> 2. Turn Off you cr to the console and to the Overfill Alarm. Remove the It between the Output Relay connections. <br /> OVERFILL ALARM WITH ACKNOWLEDGEMENT SWITCH <br /> 1. Stand by the Acknowledgement Switch and have someone reapply power to the console and Overfill Alarm.If the <br /> Overfill Alarm is wired properly,the alarm horn should sound immediately followed by the red alarm light flashing. <br /> 7 <br />