COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

UNDERGROUND STORAGE TANK MONITORING SYSTEM CERTIFICATION FORM VIII . MONITORING SYSTEM AND PROGRAMMING This section must be completed if a monitoring panel is used to perform leak detection monitoring. Y N NA Are the visual and audible alarms operational? [i] ❑ ❑ Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, E ❑ ❑ functionally tested , and confirmed operational? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their ❑ ❑ proper operation? Was monitoring system set-up reviewed to ensure proper settings? Pol ❑ ❑ Was the monitoring panel's backup battery visually inspected , functionally tested , and confirmed operational? E ❑ ❑ Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment? I] ❑ ❑ Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically I] ❑ ❑ disconnected? Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? HI ❑ ❑ Which sensors initiate positive shut down? (Check all that apply.) [] Sump ❑ Under-dispenser containment If alarms are relayed to a remote monitoring station , is all communications equipment (e. g , modem) operational? ❑ ❑ Foran answer of "N" above, describe in section lX how and when these deficiencies were or will be corrected. IX. COMMENTS X. IN -TANK GAUGING TESTING Q Check this box if tank gauging is used only for inventory control . (Do not complete this section.) ❑ Check this box if NO tank gauging equipment is installed . (Do not complete this section.) Y N NA _ This section must be com leted if in-tank au in is used toerform leak detection monitorin . Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination , including testing for ground M ❑ ❑ faults? Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely, functionally tested , O ❑ ❑ and confirmed operational? Was accuracy of system's product level readings tested ? El ❑ Was accuracy of system's water level readings tested? EI El Ell Were all probes reinstalled properly? El E] Were all items on the equipment manufacturer's maintenance checklist completed? El 1:1 For any answer of "N" above, describe in section XI how and when these deficiencies were or will be corrected. XI . COMMENTS Probes were still tested . Y = Yes, N = No, NA = Not Applicable