Laserfiche WebLink
STEP 6: APPLY GREASE TO DROP TUBE <br />Apply black moly grease to the inside diameter of the <br />upper droptube. Make sure coverage is completely <br />around the tube as shown in Figure 6. <br />Figure 6 <br />STEP 7: APPLY GREASE TO POLYPAK SEAT. <br />Ensure that the polypak seal is installed on the inlet <br />tube with the fip up as shown in Figure 9. Apply black <br />moly grease to the polypak as shown. Make sure cover- <br />age is completely around the polypak seal. <br />E=nsure polypak <br />around polypak <br />Figure 7 <br />STEP 8: INSTALL INLET TUBE <br />Insert the inlet tube into the upper tube until the upper <br />tube seats against the flange on the inlet tube. Ensure <br />polypak is inserted evenly and stays in inlet tube <br />groove. <br />Figure 8 <br />NOTE. Testable inlet tube must have cable port in <br />line with float. Testable inlet Mabe bottoms out on <br />stop, it does not bottom out on inlet Range. See Fig- <br />ure 8A <br />Cable port must be in <br />line with float <br />Figure 8A <br />Testable Models Only <br />SEE PAGE 8 FOR INSTRUCTIONS USING THE 77 5O_ <br />SEE PAGE 9 FOR INSTRUCTIONS USING THE 71 SO - <br />SEE PAGE 10 FOR INSTRUCTIONS USING THE uS <br />Note., testable 77SO modeis ending with u `rrequire the <br />71SO-TOOLCT or modified 7150 -TOOL or 71 SO- WOLC <br />