Laserfiche WebLink
TESTABLE PROCEDURE ONLY, FOR STANDARD MOD- <br />ELS, PROCEED TO NEXT PAGE. <br />STEP 1T: INSTALL SOCKET ADAPTOR ASSY <br />Put cable thru threads in inlet tube and out thru cable <br />port on side of inlet tube. Thread the socket adaptor <br />assembly finger tight into the inlet tube. Note; the ca- <br />ble porton the inlet tube must be in line with the float <br />as shown previously in Figure 8A. <br />Socket <br />adaptor <br />assembly <br />Cable <br />port <br />Figure IT <br />STEP 2T: PASS CABLE THRU 1FE14RULE <br />Pass cable thru ferrule. Loop cable and then pass cable <br />back thru ferrule. Keep ferrule loose until cable length <br />is determined in the next step. Note: if cable end frays <br />it may be necessary to trim the cable again to pass thru <br />ferrule. <br />11$" Inandrel <br />rivet <br />Ferrule <br />Trim <br />cable _�-- <br />after <br />step 3T Loop <br />Figure 2T <br />STEP 3T; DETERMINE CABLE LENGTH <br />Run cable along upper tube and over the top plate on <br />the float bracket as shnwn. With the float in the down <br />position (as shown in Figure 3Tj align loop in cable with <br />rivet and top hole in float bracket. Use the rivet as a <br />template to size the loop in the cable and pull cable <br />tight and crimp ferrule with crimping tool 1 pliers onto <br />cable at this location. Trim excess cable with wire cut- <br />ter / scissors. For reference, from the seam where the <br />upper tube and valve body meet to the end of the cable <br />after trimming will require approximately 3.5" of cable. <br />Sei <br />Figure -11 <br />Cable over float bracket <br />STEP 4T: ATTACH CABLE TO FLOAT BRACKET <br />Ensure cable is over the Float bracket. Using the sup- <br />plied rivet align loop in cable with top hole in float <br />bracket and pass rivet thru cable loop and float bracket <br />hole. Using rivet tool for 118'° dia mandrel attach rivet <br />and cable to the float bracket. See.last page for list of <br />replacement cable parts. <br />Figure 4 <br />hole <br />STEP 5T: ENSURE PROPER CABLE OPERATION <br />Unthread the socket adaptor assembly from the inlet <br />tube and ensure float and poppet move freely when <br />socket adaptor assembly is pulled on, It should only <br />require 3" to 4" of movement in order to actuate the <br />float and poppet. Thread socket adaptor assembly fin- <br />ger tight into inlet tube after testing. <br />13 <br />