COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

STEP 20: PREPARE FILL RISER FOR VALVE INSERTION IMPORTANT: Inspect the riser pipe for any foreign material, Over spray from tank relining or any internal burrs inside of pipe must be removed prior to installa- tion. Failure to have an unobstructed riser pipe may prevent proper installation or operation of the valve. Thoroughly clean top of riser pipe. STEP 21: REMOVE ELASTIC BAND Remove the elastic band securing the float to the valve body, The float will move into an outward position. STEP 22: INSERT DROP TUBE Make sure the upper O -Ring gasket is under the flange of the inlet tube. Hold the float down against the valve body and slowly insert the drop tube overfill valve into the riser pipe. Do not force valve -into the riser pipe. if any obstruction or foreign matter interferes with smooth !risertion of Lhe valve, the riser pipe must be cleared. WARNING Failure to follow the assembly and installation Instructions or use of excessive force to insert the OPW 71 SO will VOID THE WARRANTY. Difficulty in removing the existing fill tube (if there is one) means there may be an obstruction in the riser pipe. Look for burrs, defor- mations, excess tank lining materi- al or other projections that may interfere with easy insertion of the DPW 71 SO. The 71 SO is designed for insertion into schedule 4g pipe. If Figure 22 schedule 8o pipe has been used for the riser, the 71 SO cannot be installed. If seamed pipe has been used, the internal weld bead may interfere with the OPW 71SO and prevent installation. If the DPW 71 SO won't slip in easily DONT FORCE 1T! Damage to the valve may result if excess force is used. Examine the riser pipe carefully, determine the nature of the obstruc- tion, take appropriate steps to remove it, STEP 23: CHECK INSTALLATION Insert the drop tube all the way into the tank until the flange and gasket seat onto the top of the Face Seal Adaptor. The float will swing out into the operating position as it passes into the tank. Figure 23 Make sure that the float is aligned along the length of the tank. The length of the tank can easily be deter- mined by locating other manholes or pump boxes that are installed around other tank fittings. Look into the drop tube and align the deflector with the length of the tank. Fortes able m els only: Unthread the socket adap- torassembly from the inlet tube (a 318" square drive extension will attach to the socket adaptor, secure all tools to ensure they don't fall into the tank or valve) and ensure float and poppet move freely where socket adap- tor assembly is pulled on. When looking down into the upper tube ensure poppet is visible when socket adap- tor is pulled and resets properly when socket adaptor is released. See page 17 for full testing details. if poppet does not actuate freely take appropriate Steps to correct before proceeding. CAUTION: No obstruction in the tank can be within 14" from the center of the riser pipe or the valve may not operate properly (See Figure 24). SCEP 24: ALIGN VARVE Install the DPW Jack Screw Kit and a 4" NPT nipple to lock the valve in place. Refer to the Installation Instruc- tions supplied with the Jack Screw Kit. Fortestable models ensure that the socket adaptor is aligned so it does not interfere with the jack screw kit. (see rig_ ure 24A). Install the Rotatable Product Adaptor (Refer to Installation instructions supplied with the Product Adaptor.) Make sure that the valve does not rotate while tightening the adaptor by observing the position of the deflector. The value must remain aligned along tha I-anyth e f the tank as in Step 23. Repeat this step as necessary to assure proper valve alignment. 14