COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

Phil-Tite Installation , Operation and Maintenance Manual , Page 19 Executive Order VR- 101 -N Step 2 — Dry Fit All Components Dry fit your riser to verify your measurements , After you have dry fit all components and are satisfied with your measurements , apply an approved fuel resistant , non hardening thread sealant ( pipe dope ) to the NPT threads on tank end of the risers . Step 3 — Install Tank Risers Install and torque the tank risers into the tank bungs per tank manufacture instructions . Step 4 — Install the M - 1600 Riser Support Bracket before you install the M/F 4X4 Riser Adaptors Install the M- 1600 Riser Support bracket between the two 4 inch ( Fill and Vapor) tank risers just below the top of the tank riser threads for the MIF 4X4 riser adaptors . Tighten and/or set the turn buckles to maintain the space between the two tank risers at 16 inches on center. Step 5 — Check your dimensions With the M/ F 4X4 riser adaptors and spill containers dry fitted , check the dimension from the top of the spill container to finish grade . You should have 4- '/Z inches to 5 inch clearance . Verify the height of the fiberglass platform . Check for 1 'h inches of clearance between the top of the platform and the bottom of the composite manway cover. Step 6 - Install the M/F 4X4 riser adaptors Using the M/F 4X4 Riser Adaptor Installation Instructions install and torque the M/ F 4X4 riser adaptors . Step 7 — Install the fiberglass platform before installing the 85000- EXT Spill Containers . The Watertight Fiberglass Platform must be installed and latched down before the 85000-EXT Spill Containers can be installed . You are now ready to install the 85000-EXT Spill Containers . Refer to the 85000-EXT Series Spill Container Installation Instructions on the following pages .