COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

PhikTite Installation , Operation and Maintenance Manual , Page 20 Executive Order VR-101 -N 85000 -EXT Series Spill Container Installation Step 1 — Preparing the Black Spill Container for Installation A . Inspect the black spill container ensuring that the '/ inch flat seal is in place and properly oriented for sealing onto the flared top of drop tube ( Fill ) or on the M/F 4X4 Riser Adaptor (vapor) . On Fill spill containers ensure the drop tube has the special PhikTite seal ( 85039- DT) installed under the upper drop tube flare and is seated on top of and inside the M /F 4X4 riser adaptor installed on top of the tank riser. If you are using a straight drop tube from a different manufacturer, discard the " O "- Ring that may have been shipped with this drop tube and use the special PhikTite seal ( 85039-DT ) that is shipped with each Fill Spill Container. B . 85000- EXT Fill Spill Containers . Inspect the foam filter located inside the container. The filter should be lying flat and secured by the stainless steel retainer ring . Move the drain valve handle back and forth making sure that the lower screen assembly rises (compresses ) when moved to the open position and extends when closed . The drain valve handle should move freely with no binding and snap into place when moved to the closed position . C . NOTE : DO NOT USE ANY TYPE OF THREAD SEALING COMPOUND ( Pipe Dope) FOR SPILL CONTAINER INSTALLATION ! Apply an even coat of Silicon based Spray or Lubrisilk Marine Boron CLS Bond Spray to the black spill container female threads and to the M /F 4X4 riser adaptor male threads or apply a light coating of anti-seize compound . This will reduce the friction between these threads during installation and aid in removal of the spill container at a later date . Step 2 - Install the Black Spill Container onto the M/ F 4X4 Riser Adaptor By hand , thread the black spill container onto the male threads of the M/ F 4X4 riser adapter, taking care not to cross thread the spill container riser threads . These threads are straight threads , not NPT pipe threads . The spill container must screw down and seat on the top of the drop tube flare ( Fill ) or on the top of the M/ F 4X4 riser adaptor sealing surface (Vapor) . Step 3 — Tightening the Spill Containers Using a Y2 inch drive torque wrench and the special tool adapter (T-7101 or T-7002A, Black) from PhikTite Tool Kit (T-7043 ) , tighten the Spill Container onto the M/ F 4X4 Riser Adaptor threads to a torque value between 75 and 100 ft. lbs . Step 4 — Final Installation Check Watertight Platform - ensure that the top of the spill containers are even with or just below the top of the platform and the watertight boots are installed (small end around the platform openings , large end around the spill container(s ) . Check to insure that the watertight latches are closed . Step 5 — Drain Valve Testing Test the drain valve assembly as described in ARB test procedure TP-201 . 1 D . The spill container is now ready for the installation of the rotatable (swivel ) adaptor and dust cap . Install the fill and/or vapor swivel adaptor using the SWF- 100 series/SWV- 101 series Installation Instructions . Torque the swivel adaptor to a value between 50 and 75 ft. lbs .