Laserfiche WebLink
i <br /> i <br /> i <br /> 1 <br /> CODE OF SAFE PRACTICES <br /> FLYWHEEL GRINDER <br /> JOB SUMMARY: Sinoothes flywheel. <br /> SKILLS REQUIRED: Able to count and handle sharp objects and be safety conscious. <br /> EMOTIONAL Ability to handle repetitive work. Follow directions. <br /> STANDARDS: Ability to interact in a multi-cultural environment. Detail oriented. <br /> PHYSICAL Good eyesight with or without corrective lenses. Strong physical health. <br /> STANDARDS: Ability to stand for long periods of time on hard surfaces. f <br /> JOB HAZARDS: Repetitive motions. Working with bent wrist or extended elbow or both. <br /> Lifting,twisting and turning. Cuts and abrasions. <br /> SAFETY <br /> EQUIPMENT <br /> REQUIRED: Gloves. Safety glasses. Face shield. <br /> SAFE CONDITIONS: i <br /> Employees shall be properly instructed on the hazards of their work and of safe practices by bulletins, <br /> printed rules,verbal instructions and periodic safety meetings. <br /> [ SAFE PRACTICES <br /> V <br /> 1. Smoking is allowed in designated areas only. <br /> 2. Never be in front of spinning disk. <br /> 3. Always turn off machine when not in operation. <br /> 4. Make sure bar is in guide securely before pulling or shaping. <br /> 5. Clean area around grinder. <br /> 6. Oil to be used on each and every disk before shaping. <br /> 7. Operate with guard in safe position. <br /> 8. Grinder motor must turn clockwise-top view. <br /> 9. Securely tighten grinder head clamp before starting table rotation. <br /> 10. Always start table rotation before grinding rotation. j <br /> 11. Inspect disk for cracks prior to start up. <br /> i <br /> 12. Follow all Company safety rules and policies. <br /> 13. Employees must report all unsafe conditions and accidents immediately to a Supervisor. <br /> 14. No horseplay is permitted. <br /> 15. Clean worksite conditions must be maintained at all times. <br /> 16. All Personal Protective Equipment(PPE)required by State or Federal Regulation must be worn. <br /> 17. All equipment guards required by State and Federal Regulations must be in place. <br /> 18. Use Lockout/Tagout/Blockout procedures when required by State or Federal Regulation. <br /> 19. Inspect equipment prior to each use. <br /> 20. Only operate equipment that you have been trained and authorized to use. <br /> 21. All electrical wiring shall be to code and maintained in safe condition. <br /> 22. Use proper lifting techniques. <br /> 23. Only qualified personnel can perform maintenance services. <br /> 24. Follow all Manufacturers safety guidelines. <br /> 25. Do not operate equipment under the influence of altering prescription drugs,illegal drugs and/or <br /> alcohol. <br /> 26. Ensure that all Warning,Caution and Danger signs are in place. <br />