COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

EBW Phase I Equipment Required Inspection & Maintenance Spill Containment Manholes Drop Tube Mounted Overfill Prevention • Perform inspection and maintenance duties at least Valves once a year. • Perform inspection and maintenance duties at least • Remove any standing liquid and dispose of it properly. once a year. • Brush all buildup off of the brass drain valve screen of • Inspect the inside of drop tubes for broken dip sticks or applicable). noticeable damage to the valve flapper. If any damage is • Remove all dirt and foreign materials. observed, then the valve must be replaced. • Scrape all foreign materials away from the tank lid • If it has not already performed during drain valve testing, sealing surfaces. leak test the Drop Tube assembly using the established • Should it be necessary to replace a drain valve due to "Pressure integrity Test"for Drop Tube/Overfill breakage or considerable contamination buildup, use Prevention Device (TP201.1C or TP201.1❑). EBW 705.337-19 Replacement Drain Valves only. EBW doesn't require that the drop tube be pulled for • Perform a leak test using the established "Pressure inspection unless damage is noted. Should local authority Integrity Test"for a combination of Drop Tube, Drain require removal of the drop tube, the following seals and Valve, and Overfill Prevention Device (TP201.1 D). inspection steps are necessary: • Use 90079 Drop Tube Isolation Test Kit. Replace Drop Tube Isolation Gland (if applicable) seal Rotatable Fill & Vapor Adapters, Dust Caps & kit-90090 Probe Riser Adapters Replace Drop Tube Flange Gasket--11182-01 • Perform inspection and maintenance duties at least Inspect the Tank Bottom Protector for freedom of once a year. movement. Repair or replace if necessary. • Inspect all product and vapor riser dust cap seals for Inspect OPD components, use instructions on EBW damage. If damage is observed, replace the seal with from 6329. either the Aluminum Vapor Cap Seal or the Nylon • inspect drop tube jaint sealant. Repair with EBW part# Product Cap Seal. 11372-01 only. • Perform Rotatable Adapter maintenance as specified by Ball Floats & Extractor Valve Bodies Phil-rite Enterprises, Inc. Perform established 'Static . No annual maintenance is required. Torque Test", TP201.1 B. • Leak testing should be accomplished during the Pressure Vacuum Vent Valves "Pressure Integrity Test"for a drain valve or Drop Perform the required maintenance as specified by Tube Mounted Overfill Valve,TP201.1 C or TP201.1❑- Dusky Corporation. Annual maintenance of the probe riser cap assemblies At least once every three years, unless otherwise specified is normally not required. Whenever probe service is by a local authority, perform the established"Static necessary, inspect the service cap seal for damage and Pressure Performance Test" JP201.37. replace it, if necessary, at that time with a Probe Riser Cap Seal. Please contact Technical Support if assistance is needed. 4a Franklin Fueling Systems 3760 Marsh Road Madison,WI 53718,U.S.A. Tel:+1 608 838 8786 Tel:USA&Canada 1 Boo 225 9787 Tei;Mexico 001 800 738 7610 C 2015 F-6308 rev 3 www.franklinfuelMg.com