COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

71S0-TOOLC PROCEDURE BELOW, Caution : If the drill stop is not in the proper FOR 71S0 -TOOL , SEE PAGE 8 location failure of a pressure decay leak test may result. STEP 913 : INSERT 71S0-TOOLC OVER INLET 71 SOJOOLIC TUBE To install the 71 SO-TOOLC (sold separately) over the inlet tube , first loosen the thumb screw , so the o tool can pass freely over the inlet tube flange . Align the slot on the tool with the key on the inlet tube and insert the tool down . See Figure 9B . Tool Slot Hand tighten thumb Tip to stop dimension o screw must be 1 -3/ 16 " to 1 - 1 /4" o d Figure 11B Loosen thumb screw STEP 12B : DRILL HOLES With the inlet tube and 71 SO -TOOLC in place , Inlet carefully drill a 3/ 16" diameter hole in the upper tube Tube using the hole in the 71 SO-TOOLC as a guide . The Key drill stop is positioned so it will bottom out against the tool after the bit has drilled through the upper drop tube . If the stop is positioned wrong either no hole will be drilled , or a through hole could potentially be drilled through the inlet tube . If no hole is drilled return to step 11 and check the stop dimension . If a hole is drilled through the inlet tube or into the screw hole the assembly is not salvageable . Drill (2) more holes in the two Figure 9 Figure 10 remaining guide holes . STEP 1013 : TIGHTEN THE 71S0 -TOOLC o i Ensure that the tool seats flat against the top of the inlet tube . To prevent vertical movement of the tool during drilling , hand tighten the thumb screw against I the upper drop tube . See Figure 10B . STEP 11 B : PREPARE DRILL AND BIT Confirm that the stop on the 3/16" drill bit supplied Drill through upper tube only with the 71 SO-TOOLC is in the correct position before drilling . The stop is factory installed at a distance between 1 -3/16" to 1 - 1 /4" from the tip with the 71 SO -TOOLC . If the stop is not at the correct Figure 1213 position it must be fixed before drilling . 69