WORK PLANS - Laserfiche WebLink

Home Browse Search

Oracle #03150276 EF-1 Item # 476 RECOMMENDED BLOCKING: Tap If the walls do not have studs on center,then additional blocking is necessary(Fig. e). 1 Contact an architect or building contractor to make sure the blocking (210 mm) is adequate and complies with building codes. For A.D.A. ance OPERATION: co 46" (117 cm) 32" Rotate base downward. Place infant on top of the changing surface. _o81cmm r~ Use restraint system as described below.After child has been changed, remove restraint system and rotate base back up against the wall. A.F.F Fig. e USE OF RESTRAINT SYSTEM: Place child so restraint strap is located at abdomen. Rotate top of buckle upward and insert strap Locking in buckle. Pull strap through buckle until snug against infant. Rotate top of buckle downward to lock Top Of the strap into place. Slide red locking tab over top of buckle(Fig.o. Reverse steps to loosen strap. Buckle Tab MAINTENANCE AND CLEANING: ♦� Check all hardware and components monthly or as required to ensure hardware is tight and there are no missing or damaged components.Take unit out of service if any component is missing or damaged and contact customer service to order replacement parts. Do not substitute parts. For replacement parts, contact customer service at 1-877-716-2757. Clean by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use any strong Fig. f chemical cleaners or cleaning agents that may be hazardous to children. • Child should never be left unattended. • Avoid serious injury from falling or sliding out.Always use restraint system. • Adding excessive weight such as parcels, packages, or accessories to the unit or to the bag hooks that exceed the total weight limit of 50 pounds(22.7 kg) may cause the unit to be unstable or may cause a hazardous unstable condition to exist. Using Backer Plate Mounting System: If your changing station was supplied with a backer plate, please follow these instructions. If a backer plate was not supplied and you would like to order one, see information on page 1. The backer plate is designed to enhance the attachment method to ensure that at least one wood stud is used to support the changing station. 1 • A stud MUST be located and used for at least one side of the diaper changing station. • The diaper changing station is no stronger than the anchors or walls to which they are attached and,therefore, MUST be firmly secured in order to support the weight they are intended to support. Contact an architect or building contractor if any questions. • Use backer plate mounting system with at least four(4)standard mounting screws.The backer plate alone is NOT a secure attachment method. 1. Locate wood stud where left side of changing station will be mounted to the wall. 2. Measure up 46"(117 cm)from the floor and mark the wall. NOTE:Mark on wall MUST be in center of wood stud. 3. Using two(2)3"wood screws and a level, mount the backer plate to the center of the wood stud (Fig. g). NOTE:The lip of the backer plate MUST be facing away from the wall (Fig. h). Repeat steps to secure backer plate to another stud on the opposite side. / Side view of Fig-g / Backer Plate 4. Slide recessed area on back of changing station onto lip of backer plate. 5. Return to installation step 5. / BackerLnf0ameraprtoLdur6ts'5c,C,m1F ued by Plate Lip Products.com 3 Fig. h 0)608. 58 )84 .com