Laserfiche WebLink
Oracle #03150276 EF-1 Item # 476 <br /> • A stud MUST be located and used for at least one side of the diaper changing station. <br /> • The diaper changing station is no stronger than the anchors or walls to which they are attached and,therefore, MUST be <br /> firmly secured in order to support the weight they are intended to support. Contact an architect or building contractor <br /> if any questions. <br /> INSTALLATION <br /> NOTE:If using a backer plate,go to"Using Backer Plate Mounting System"section. <br /> 1. Locate wood stud where left side of changing station will be mounted to the wall. Flat <br /> Wood Stud <br /> 2. Measure up 46"(117 cm)from the floor and mark the wall.This locates the position <br /> Washer <br /> for the top left attachment hole. <br /> Finishing <br /> NOTE:Mark on wall MUST be in center of wood stud. Washer <br /> 3.Align hole in top left corner of changing station with mark on wall and hold in place. Wood <br /> 4. Using a level and measuring tape, mark the remaining three(3)holes.After marking holes, Screw c= <br /> set changing station down on ground. <br /> Changing /Fig.a <br /> 5. Use a power drill and appropriate bit to drill four(4)holes in the wall.This may require Station <br /> 2 people. <br /> NOTE 1:For wood studs: <br /> - If finished wall surface is tile or masonry over wood studs, use Toggle <br /> a 7/32" masonry bit for the pilot hole until you hit the wood Wood Stud Anchor <br /> stud,then change to 1/8" bit. lat <br /> Changing <br /> - Use wood screws,finishing washers and flat washers (Fig. a). Washer <br /> NOTE 2:For use with toggle anchors: Station <br /> - If finished wall surface has wood studs that are not 16"on center, hine <br /> has metal studs, or has an underlying surface of concrete block, <br /> iNrew <br /> use 1/2"bit. <br /> Fig,b <br /> - Use machine screws and flat washers(Fig. b). <br /> - For holes NOT located in a wood stud,toggle anchors MUST be <br /> used (Fig. c). See"Using Toggle Anchors"section. <br /> 6.Align holes in changing station with drilled holes and secure top left corner of changing <br /> station to wall stud using the appropriate screw and washer. Continue to secure the Fig. c <br /> three(3)remaining corners using the appropriate screws and washers as described <br /> in Note 1 or Note 2. <br /> t110 <br /> • All 4 of these locations MUST be used for safe installation.The lower holes ensure <br /> installation through the metal brackets. <br /> 7. Ensure all four(4)screws are tight and snap caps over screw heads. <br /> Using Toggle Anchors: Toggle <br /> Wood Stud gg <br /> 1. Insert metal end of toggle anchor into 1/2" hole. <br /> Anchor <br /> 2. Slide zip strip down snugly against wall. <br /> 3. Snap off break-away pieces of toggle anchor(Fig. d). Break-Away <br /> 4.Align holes in changing station with toggle anchors and secure top left corner of changing station to / <br /> wall using machine screws and flat washers. Continue to secure the three (3)remaining corners I <br /> using machine screws and flat washers. <br /> Fig. d <br /> 5. Ensure all four(4)screws are tight and snap caps over screw heads. <br /> Distributed by <br /> www.Amer&Products.com <br /> w.Amer&Products.com <br /> Ph•n•:(900]649.6568 <br /> Fa;(409)940-5545 <br /> infe®ameraproducts.cem <br />