Laserfiche WebLink
❑ Assorted screwdrivers (flat blade-one must be 1/8" wide and Phillips) <br /> ❑ 5/8" copper tube bending tool <br /> ❑ 5/8" copper tube flaring tool <br /> ❑ Copper tubing cutter <br /> ❑ Electrical multi-Deter <br /> ❑ Small hand brush (1-1/2" thick, for clearing chips) <br /> ❑ 12" adjustable wrench <br /> ❑ 10" pipe wrench <br /> ❑ Tape measure <br /> ❑ Allen wrenches <br /> 6. DISPENSER ACCESS: <br /> ❑ Secure Dispenser Access keys from Station Management. <br /> ❑ Lock-out and tag-out all electrical power to dispenser being modified. <br /> ❑ Remove both lower dress panels. <br /> ❑ Remove side skin on the left side as viewed from the `A side (`J' box). This is the side <br /> where the 1" balance vapor pipe is installed. <br /> ❑ Open both upper doors to the electronics compartment. <br /> 7. SURVEY— Scope of Work: Perform this step before beginning steps 8 thru 10. <br /> Read and familiarize yourself with the theory of operations sheet and wiring instructions for <br /> the VP1000 Vapor Pump. The installation of the pump is accomplished by rotating the motor <br /> mounting bracket bolting it to the dispenser frame on the same side as the electrical `J' box <br /> in the free space on the left hand side, see photos E & F. From this survey, you will have an <br /> indication of where the vapor plumbing fittings need to go and where the electrical conduits <br /> need to be routed. The Healy potted conduit nipple is installed in the vapor barrier above the <br /> meters, in a 1 1/8" hole that is already available but is plugged. See Photo K and Section 9. <br /> CAUTION: ALL POWER TO DISPENSER UNDER MODIFICATION SHOULD BE <br /> COMPLETELY DISCONNECTED AND CAPPED OFF AT JUNCTION BOX TO AVOID <br /> UNINTENTIONAL FEEDBACK FROM OTHER DISPENSERS!! <br /> 8-5 <br /> CARO Approved IOM 8-Wayne Vista Series-Executive Orders VR-201 and VR-202 <br />