Laserfiche WebLink
� <br /> j,e. <br /> Photo E Photo F <br /> 8. INSTALLING THE HEALY VP1000 SYSTEM: <br /> ❑ Locate the 1" vapor down pipe on the side of the cabinet and remove the `U' bolt that <br /> secures the pipe to the cross rail in the hydraulics area. <br /> ❑ On the top of the down pipe, loosen the two flare nuts and release the two vapor pipes <br /> coming into the tee from each side of the dispenser. Caution: the pipe is now loose and <br /> could fall down, see photo G. <br /> ❑ Remove the pipe from the dispenser and remove the tee from the pipe. Save the tee, <br /> discard the pipe. <br /> ❑ Use pipe dope and install a 1" x 1/2" NPT reducer bushing into the branch of the tee. <br /> ❑ Install a 1/2" NPT x 5/8" straight flare fitting into the reducer installed above. <br /> ❑ Re-install the tee back into the dispenser with the branch facing downward and re-connect <br /> the vapor tubes removed earlier. Be sure to tighten the vapor tube flare nuts securely, see <br /> photo H. <br /> ❑ Get the VP1000 pump and looking from the front (pump end), remove the four screws <br /> holding the black mounting bracket to the motor and reposition the bracket 90° clockwise, <br /> then re-install the screws. This keeps the pump inlet in the correct "up" orientation when <br /> mounted in the cabinet, see photo E. <br /> ❑ Place two of the 1/4"- 20 mounting bolts, flat washers, lock washers and nuts loosely <br /> together and into the slots on the motor mounting base. <br /> ❑ On the left side of the cabinet (`A side with `J' Box), notice the three keyhole punch-outs, <br /> see photo F. Lift the motor and push the washer/nut combinations through from inside the <br /> cabinet to mount the motor tight to the side frame. <br /> 8-s <br /> CARR Approved IOM 8-Wayne Vista Series-Executive Orders VR-201 and VR-202 <br />