Laserfiche WebLink
Dispenser Specific Wire Harness Installation <br /> 1. Locate the solenoid valve control board used to supply power to the product solenoid valves. <br /> 2. Locate the plug connector or connectors that supply power or signals from the solenoid valve control board to the <br /> individual solenoid valves. <br /> 3. Remove the existing connection between the solenoid valve control board and the solenoid wire connecting plug(s). <br /> 4. Some dispensers will have separate solenoid valve connection points on the solenoid valve control board. The Healy <br /> control module wire harness for these dispensers will also be separated. Channel 1 input harness connects to the "A" <br /> side of the solenoid valve control board. Channel 2 input harness connects to the "B" side of the solenoid valve control <br /> board. <br /> 5. Plug the cable connector(s)from the Healy Control Module into the mating connector(s) located on the solenoid valve <br /> control board. Do not force the connection.The connector installed on the Healy Control Module should match the <br /> original connector removed from the solenoid valve control board. <br /> 6. The Healy wire harness is now connected at the solenoid valve control board. Be sure the plug connector(s) have <br /> properly locked into place ensuring a tight connection. <br /> 7. Plug the previously removed solenoid wire connecting plug(s) into the mating connection on the Healy control module <br /> wire harness. This step will complete the dispenser interface wiring to the Healy Module. <br /> AC Power to the module <br /> 1. The MC100 Module requires a constant 120vac- 2 amp power source from the dispenser. The power should be <br /> supplied from the main power strip or accessory connections capable of sustaining a 2 amp load. <br /> 2. Using a 3M ScotchLok supplied with the 1360A Module assembly, connect the factory installed black&white twisted <br /> pair on the MC100 Module to the black and white (power& neutral)from the main power source or accessory <br /> connection of the dispenser. <br /> Shown below are the Dispenser Specific Interface Wire Harnesses listed in the Dispenser Models chapter of this manual. <br /> 0 <br /> Iwo <br /> 1354 Wayne& DL Non-Blender 1363 Wayne 1V&2V Blender 1368 Early Gilbarco Encore 300 Blender <br /> ❑ ❑ <br /> 1362 Tokheim Premier C Blender 1372 Early Tokheim Blender <br /> 8-II <br /> CARB Approved IBM 8-Healy Universal Manual-Executive Orders VR-281 and VR-282 <br />