Laserfiche WebLink
Generic Dispenser Wire Harness Installation - 1360A <br /> The 1360A Generic Wire Harness/Control Module is universal and can be installed in any dispenser or suction pump. <br /> Descriptiona was <br /> MC100 Control Module 1 40 *e* <br /> Wire Nuts Red 4 CA was <br /> Wire Nuts Orange 2 was <br /> ScotchLok Red I 13 <br /> 12' Brown #16 Wire 1 ' I • •••••• •••••• <br /> 12' Blue#16 Wire 1 • <br /> • RELA <br /> Z,B L 03 • <br /> Note: Solenoid valves that supply diesel do not connect to the • • <br /> MC100 Control Module. FAULT 0 • <br /> • POWER 0 <br /> 1. Locate the solenoid valve board that controls the signals (AC or • <br /> DC) entering or exiting the product solenoid valves. FFF ; <br /> "Re"03 <br /> 2. Locate the dispenser wire harness that carries the signals from the •' <br /> solenoid valve control to the individual solenoid valves on each <br /> side of the dispenser. <br /> A Side <br /> 3. Starting on the "A" side of the dispenser and using a multi-Oeter, determine which harness wire is carrying the voltage <br /> signal to the "A"side—grade 1 solenoid valve. <br /> 4. If a solenoid valve assembly has more than one signal wire, the signal wire that is first energized and remains <br /> energized throughout the fueling is labeled. <br /> 5. Each individual solenoid valve signal wire supplying the "A" side of the dispenser must be located and labeled; for <br /> example:A grade 1,A grade 2,A grade 3. <br /> 6. Loosely place a 3M ScotchLok onto the first signal wire ("A grade 1")then measure and cut the appropriate length of <br /> blue wire supplied with the 1360A module assembly. One end of the blue wire is placed in the Scotchlok connector and <br /> fastened to the signal wire. The other end is stripped and placed into the Channel 1 Input/ Position 1 of the MC100 <br /> Control Module. <br /> 7. Repeat Step 6 for the next solenoid valve and all remaining valves that supply the "A" side of the dispenser.Attach <br /> each of the "piggy-back" signal wires separately into the next available position(s)2,3,4 on the Channel 1 Input side of <br /> the MC100 Module. <br /> SOLENOID <br /> DISCONECT <br /> i <br /> I LL 0 0 <br /> FAULT .. <br /> NI 8�lWd <br /> Attaching the Voltage Signal Wire(s) to the MC100 Control Module <br /> 8-12 <br /> GARB Approved IBM 8-Healy Universal Manual-Executive Orders VR-281 and VR-282 <br />