Laserfiche WebLink
c) With the suction line disconnected from the Liquid Condensate Trap and disconnected <br /> at the turbine syphon port, blow compressed air through the suction line to remove any <br /> debris and check for any blockages. <br /> 4. INSTALLATION OF THE PHASE II EVR EQUIPMENT LISTED IN EXHIBIT 1 <br /> OF EO VR 201 AND 202 <br /> Figures 1 through 3 show a typical layout of a Phase II EVR Liquid Condensate Trap after <br /> completion of installing the equipment listed in Exhibit 1 of EO VR 201 and VR-202. <br /> Figure 1 <br /> Typical Liquid Condensate Trap Installed Below the Transition Sump <br /> RISER w/LIQUID SENSOR INCON TSP-K2A RISER CAP & ADAPTER <br /> MUST USE A REDUCER ON 3" RISERS <br /> PRODUCT PIPING SUCTION RISER with Fittings/Components per <br /> MONITORING RISER Exhibit 1 of the Executive Order <br /> qa o <br /> o <br /> ° . a FUEL ENTRY POINT <br /> a e <br /> TRANSITION BRAIDED SS HOSE OR%4" COPPER <br /> SUMP TUBING TO TURBINE PUMP <br /> VAPOR LINE LIQUID SENSOR FRP CONTAINMENT <br /> (SLOPE %$" PER PIPE <br /> FOOT MIN.) <br /> VAPOR LINE <br /> INTERSTITIAL (SLOPE%$" PER <br /> RISER FOOT MIN.) <br /> LIQUID LIQUID SENSOR <br /> CONDENSATE <br /> TRAP LIQUID SENSOR ALUMINUM /STAINLESS STEEL INSECT SCREEN <br /> w/ STAINLESS STEEL CLAMP <br /> 9-4 <br /> CARR Approved IN 9-Liquid Condensate Trap-EXECUtiVe Orders VR-201 and VR-202 <br />