Laserfiche WebLink
Installation <br /> This section discusses the installation and wiring of the hardware required to enable the TLS console to perform <br /> ISD monitoring of the site's gasoline vapor recovery equipment (non-gas tanks are not monitored): <br /> • Vapor Flow Meter <br /> • Vapor Pressure Sensor <br /> • Smart Sensor Interface Module (8 input and 7 input w/embedded pressure versions) <br /> • NVMEM board - required <br /> • 4-Relay Output Module or Dispenser Relay Module <br /> • Line Leak Detection <br /> • Dispenser Interface Module <br /> • Probe Interface Module <br /> All field wiring, its type, its length, etc., used for TLS console sensors must conform to the requirements outlined in <br /> �4 the Veeder-Root TLS-3XX Site Prep manual (P/N 576013-879). <br /> Vapor Flow Meter <br /> Install one Vapor Flow Meter in the vapor return piping of each gasoline dispenser following the instructions in the <br /> ISD Flow Meter Installation guide (P/N 577013-796). Program the meter following instructions in this manual. <br /> Vapor Pressure Sensor <br /> Install one Vapor Pressure Sensor in the vapor return piping of the gasoline dispenser closest to the tanks <br /> following the instructions in the ISD Pressure Sensor Installation guide (P/N 577013-797). Program the meter <br /> following instructions in this manual. <br /> Installing TLS Console Modules - General Notes <br /> TLS consoles have three bays in which interface modules can be installed; Comm bay (left door) and Power and <br /> Intrinsically-Safe bays (right door). Smart Sensor modules are installed in the Intrinsically-Safe (I.S.) bay only <br /> (Figure 2). <br /> Most consoles will be shipped with modules installed as ordered. If additional features are added at a later date, <br /> modules will be field installed. <br /> In all cases,the position of the modules,their respective connectors and the devices wired to the <br /> connectors must be recorded to prevent improper replacement during installation or service.A circuit <br /> directory for Power and I.S. bay Interface Modules is adhered to the back of the right-hand door for <br /> this purpose. <br /> IB-6 <br /> CARB Approved IBM 10 -Veeder Root ISO Install,Setup,6 Operation Manual-Executive Order VR-202 <br />