Laserfiche WebLink
Installation Installing TLS Console Modules-General Notes <br /> Elm5_16,.. <br /> 17 <br /> ___ <br /> 1 2 3 4 :1=4___ =6 <br /> Intrinsically <br /> 13A 5 Safe Bay <br /> __- =- -- Permissible =_ <br /> 12 4 Modules <br /> Comm Cage* - --- (Lim <br /> it _ <br /> 11 . 3 per console) <br /> ------------- <br /> 9. .1 <br /> , <br /> ISII SII I I I .--------_-------------•---------------------- <br /> Figure <br /> _ ______________Figure 2. TLS console Interface Module Bays <br /> CAUTION! During programming, module positions and the devices wired to each module are identified and stored <br /> in memory. If a connector is removed and reinstalled on a different module after programming, or if an entire <br /> module with its connector is removed and reinstalled in a different module slot, the system will not properly <br /> recognize the data being received. <br /> Module Position <br /> 1. Record on the circuit directory the type of module in each slot location. <br /> 2. If a system contains multiple modules of a single type (i.e.,two Smart Sensor Modules),they may be swapped <br /> between their respective slot locations,however,the connectors must remain with their original locations, <br /> not with the original modules. <br /> Connector Position <br /> 1. Identify all connectors according to their slot location using the self-adhesive numbering labels furnished with <br /> each module. Accurately record on the circuit directory the location of each device wired to the connector as <br /> you attach wires to the module. <br /> 2. Once a device has been wired to certain terminals on a connector and the system has been programmed, the <br /> wires from that device may not be relocated to other terminals without reprogramming the system. <br /> Grounding Probe and Sensor Shields <br /> Connect probe and sensor cable shields to ground at the console only. Do not ground both ends of the shield. <br /> CIRCUIT DIRECTORY <br /> A circuit directory is adhered to the inside of the right-hand door. It should be filled out by the installer as the <br /> module's connectors are being wired. <br /> The following information should be recorded for each slot: <br /> • Module Type: record what type of module has been installed in the slot, e.g., Smart Sensor Module. <br /> • Position Record: record the physical location and/or type of device wired to each terminal of the module <br /> connector in the slot, e.g., VFM1. <br /> IB-7 <br /> CARB Approved IBM 10 -Veeder Rout ISO Install,Setup,B Operation Manual-Executive Order VR-202 <br />