Laserfiche WebLink
Pressure Sensor Installation Tools Required <br /> MR F-1 <br /> L <br /> _.Y, ,�-�rtik,.., �• � `�1 ti �'.P i 'mss r� - <br /> a j # t <br /> S <br /> Figure 1. Table 2 Component Pictorial <br /> Tools Required <br /> 1. Wrenches suitable for tightening tubing/pipe fittings. <br /> 2. Necessary pipe fitter's equipment (including threading equipment as needed) and a non-hazardous work <br /> space suitable to modify the dispenser vapor line or the vapor vent stack for Pressure Sensor installation. <br /> 3. Torx bit for tamper-resistant screws (VR P/N 330020-635). <br /> NOTE:this bit is required to open and close the enclosure door. <br /> Under Dispenser Installation Steps <br /> 1. Before installing this device, turn Off, tag/lock out power to the system, including console and submersible <br /> pumps. <br /> 2. Determine which dispenser is closest to the tank being monitored. Remove that dispenser's lower sheet <br /> metal doors to gain access to the vapor plumbing. <br /> 3. Refer to Pressure Sensor dispenser installation examples in Figure 2 through Figure 6 to locate a suitable <br /> port or plumb a suitable fitting for the Pressure Sensor tubing in either the vapor return shear valve or in the <br /> 10-5 <br /> CARB Approved IOM 10-Veeder Root Pressure Sensor-Executive Order VR-202 <br />