Laserfiche WebLink
Pressure Sensor Installation Under Dispenser Installation Steps <br /> — Black <br /> From <br /> To i Seal-off Pressure <br /> Console i Sensor <br /> i + White <br /> 1/2" rigid <br /> conduit I <br /> Epoxy sealed connections in a <br /> 797-8.eps weatherproof junction box <br /> Figure 7. Field wiring Pressure Sensor-Observe Polarity <br /> AC 797-6.eps <br /> From sensor <br /> To console <br /> Make sure that <br /> the ends of cable <br /> sheathing are <br /> / sub-merged in seala Tie wrap <br /> Wire nuts <br /> Instructions: <br /> NOTE: When temperature is below 50°F (10°C), keep 4. Mix thoroughly to a uniform color by squeezing <br /> resin in a warm place prior to mixing (e.g., in an contents back and forth 25-30 times. <br /> inside pocket next to body). 5. Squeeze mixed, warm resin into one end of bag and <br /> 1. Open epoxy sealant package, and remove resin pak. cutoff other end. <br /> 2. Holding resin pak as shown in A, bend pak along 6. Slowly insert wiring connections into sealing pack <br /> until they fit snugly against the opposite end as <br /> long length. shown in C. <br /> 3. As shown in B, firmly squeeze the RED SIDE of the 7. Twist open end of bag and use tie wrap to close it off <br /> resin, forcing it through the center seal and into and position the tie wrapped end up until the resin <br /> BLACK SIDE. jells. <br /> OCAUTION:Epoxy sealant is irritating to eyes,respiratory system,and skin.Can cause <br /> allergic skin reaction.Contains:epoxy resin and Cycloaliphatic epoxycarboxylate. <br /> Precautions:Wear suitable protective clothing,gloves,eye,and face protection.Use <br /> only in well ventilated areas.Wash thoroughly before eating,drinking,or smoking. <br /> NOTE: Not required for wireless installations! <br /> Figure 8. Epoxy sealing field wiring <br /> 10-12 <br /> CARB Approved IOM 10-Veeder Root Pressure Sensor-Executive Order VR-202 <br />