Laserfiche WebLink
ISD Component Installat • <br /> Vapor Flow Meter Installation - Dispenser <br /> 1. A Transmitter/battery pack pair must be installed with the Veeder-Root Vapor Flow Meter(VFM) in the <br /> dispenser cabinet. <br /> 2. Install the VFM in the dispenser following instructions accompanying the VFM. <br /> 3. Using two taptite screws from the kit, attach the Transmitter housing to the side of the battery support bracket <br /> that has the two circular slots (see Figure 13). Do not tighten screws at this time. <br /> 4. Remove the cover from the transmitter.Attach the non-connector end of the cable from the VFM to the <br /> transmitter as described in the section below entitled "Connecting Cables To The Transmitter" on page 27, <br /> then attach the transmitter/L bracket assembly to the back mounting surface using two #10 taptite screws <br /> from the kit. <br /> 5. Determine a support location within the dispenser cabinet that will allow you room for the transmitter/battery <br /> support bracket. Clamp the bracket to an available support structure (see Figure 14). <br /> 6. Rotate the Transmitter antenna as close as possible to a horizontal position then tighten two mounting screws <br /> in housing. <br /> 7. Insert the battery pack into its support bracket -do not connect the battery cable to the battery pack at this <br /> time. <br /> 8. Do not replace dispenser sheet metal cover until completing the "Site Startup Procedure". <br /> 0 � <br /> 0 <br /> sea zo aP= <br /> Figure 13. Attaching Transmitter To Battery Support Bracket <br /> LEGEND FOR • <br /> 1. Transmitter <br /> 2. #10 x 1/2"taptite screws(2) <br /> 3. Battery support bracket <br /> m-22 <br /> CARE Approved IOM 10-Veeder Root TLS RF Wireless Systems(W2)-Executive Order VR-202 <br />