COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

ISD Component Installation Connecting Cables To The Transmitter Connecting Cables To The Transmitter Note:The dip switches in each transmitter must be set to the proper dip switch settings listed in Appendix B. If the dip switches are set incorrectly, this device will fail to operate properly. 1. Using a#15 torx driver, remove the cover of the Transmitter. 2. Make sure the battery/DC power cable is not connected to the battery pack(item 7 in Figure 14) or do power source at this time. QWARNING!To prevent ignition of flammable or combustible atmosphere disconnect power before • servicing. 3. Remove the nut from the probe/sensor cable cord grip (left side cord grip) and slide it over the non-connector end of the probe/sensor cable. Push the end of the cable into the Transmitter. 4. Strip back cable jacket and wires as shown in Figure 17. 5. All probe/sensor cables connect to the PROBE terminal block the SAME WAY-the white wire to the PWR terminal and the black wire to the GND terminal as shown in Figure 18. X3/32"(2.4mm) Figure 17. Connecting Input Wiring To Transmitter Terminal Blocks LEGEND • • NUMBERED BOXES IN Figure 17 1. Strip back cable and wire jackets the amount shown. 3. Both wires must be tight in terminals! 2. Use a screwdriver with the proper blade width. 6. Remove the nut from the power cable cord grip (right side cord grip) and slide it over the non-connector end of the power cable. Push the end of the cable into the Transmitter. 7. Strip back cable jacket and wires as shown in Figure 17. 8. Connect power cable wires to the BATTERY terminal block placing the white wire in the+IN terminal and the black wire in the—IN terminal as shown in Figure 18. A 9. Hand tighten both cable entry cord grip nuts to prevent water entry! 10-27 CARO Approved 10M 10-Veeder Root TLS RF Wireless Systems(W2)-Executive Order VR-202