Laserfiche WebLink
ISD Component Installation Receiver Installation <br /> m m <br /> [My ` <br /> Mme` <br /> 964-25.eps <br /> Figure 19. Attaching Mounting Bracket To Receiver Or Repeater <br /> LEGEND FOR • <br /> 1. Receiver or Repeater 4. #10 x 1/2"taptite screws <br /> 2. 0.280"diameter hole(2)—mount this narrow side of bracket to <br /> wall or post <br /> 3. Mounting bracket. <br /> 7. Referring to your connection notes in step 5 above, connect the other end of the RS-485 cable to the RS-485 <br /> terminal block in the TLS RF (ref. Figure 7 on page 16). <br /> 8. If a Repeater is used and powered by the Receiver, push the two wire power cable (to Repeater) through the <br /> +15 Vdc cord grip of the Receiver (item 7 in Figure 20). <br /> 9. Slide the nut over the cable. Choose the correct size bushing and slide it over the cable. Dress the cable <br /> jacket according to the dimensions in Figure 17. Insert the cable into the appropriate opening at the bottom of <br /> the housing. Insert each wire into the appropriate terminal and tighten. Leave a small amount of slack in each <br /> wire. Slide the bushing into the bottom of the housing. Hand tighten the nut. <br /> 10. Attach the do power cable (white to +15 Vdc and black to GND) to the Repeater terminal block (item 9 in <br /> Figure 20). <br /> Q11. Hand tighten both cable entry cord grip nuts to prevent water entry! <br /> • 12. To assure a water-tight seal between the cover and the enclosure,follow these steps: <br /> a. Insert the four cover screws through the cover and then press on the retaining washers to hold the screws <br /> in place. <br /> b. Make sure that the cover gasket is free of dirt and debris on both sides of the gasket and that the inside of <br /> the cover is clean in the gasket area. <br /> c. Position the gasket into the cover groove, assuring that it is pressed fully into the groove and sitting <br /> completely flat. <br /> d. Assemble the cover onto the enclosure, tightening the screws in a couple of turns each. Using an <br /> alternating 'X' pattern, continue to tighten the screws until they are all tight. <br /> 10-30 <br /> CARE Approved IOM 10-Veeder Root TLS RF Wireless Systems(W2)-Exeeutive Order VR-202 <br />