Laserfiche WebLink
ISD Component Installation Receiver Installation <br /> O O <br /> � - a <br /> • + O O N I <br /> 14 < C7 J3 + (y + <br /> O S2 O ¢SO <br /> m ❑ m <br /> m <br /> Q � 0 <br /> • <br /> 964-26.eps <br /> Figure 20. Wiring The Receiver <br /> LEGEND • • NUMBERED BOXES IN Figure 20 <br /> 1. RS-485 Comm Activity: 7. A solid bushing must be installed to seal the Receiver when this <br /> •XMIT(Red)LED—flashes when message transmitted to TLS- cord grip is unused.In sites where a Repeater is powered from <br /> RF the Receiver,the Repeater's power cable enters through this <br /> •RCV(Green)LED—flashes when message received from TLS- cord grip and attaches to the Repeater terminal block(item 9). <br /> RF HAND TIGHTEN BOTH CABLE ENTRY CORD GRIP <br /> •PWR(Red)LED—Receiver power on indicator A 2. Green LED—Unit status NUTS TO PREVENT WATER ENTRY! <br /> 3. Red LED—Radio status 8. S2 DIP switch <br /> 4. Connect the color pairs of the RS-485/power cable to the same 9. +15 Vdc power source for the Repeater.If used,connect two <br /> RS-485 terminals in both the Receiver and the master TLS RF wires from item 9 connector in Receiver to item 7 connector in <br /> (ref."Connecting RS-485 Wiring"on page 17). Repeater,see Figure 21. <br /> 5. S1 DIP switch <br /> 6. RS-485 cable-Maximum cable length is 500 feet if a communi- Q Pay close attention to the polarity of the +15 Vdc and GND <br /> cation grade cable is used. wires used as Repeater power source.Reversing these <br /> connections can cause damage to the TLS RF. <br /> IO-31 <br /> CARO Approved 101A10-Veeder Root TLS RF Wireless Systems(W2)-Executive Order VR-202 <br />