Laserfiche WebLink
Network Setup Site Startup Procedure <br /> Site Startup Procedure <br /> Depending on the site layout, it is permissible to install RF devices in a variety of locations including dispensers <br /> and containment sumps.After all the wireless equipment has been installed,follow the steps below to verify the <br /> final setup. For transmitters installed in Dispensers, do not close the dispenser's cover after installing the <br /> Transmitter in case signal strength is a problem. Close the dispenser's cover only after the Transmitter passes a <br /> second verification process. <br /> 1. Turn on power to the TLS RF(s) and leave the covers open. <br /> 2. Go to the first Transmitter and connect the power cable to its power source. <br /> 3. At the TLS RF you should see one of the 8 red LEDs flashing (item 5 in Figure 12).This is an indication the <br /> transmission from the Transmitter is being received. If it is, go to Step 2a. If one of the 8 LEDs is not flashing <br /> go to Step 2b. <br /> a. Go back to the Transmitter, and if applicable, replace the dispenser's cover. Return to the TLS RF and verify <br /> that the same LED is still flashing. <br /> i. If it is, disconnect the battery cable from the battery pack and repeat Step 1 on the next Transmitter. <br /> ii. If it is not, the Receiver is not picking up the Transmitter's signal. Go back to the Transmitter; remove the <br /> dispenser's cover, reorient the antenna or lower the Transmitter,then go back to the TLS RF to verify <br /> that the same LED is flashing. <br /> iii. If reorienting the antenna or moving the Transmitter doesn't help, disconnect the battery cable from the <br /> battery pack and make a note that the signal is not being received at this particular dispenser. <br /> iv. Repeat Step 1 with the next Transmitter. <br /> b. If applicable, go back to the dispenser, remove the Transmitter's cover; the green LED (item 2 in Figure 5) <br /> should be flashing indicating that the sensor is being read. If the green LED is not flashing, check the <br /> sensor cable's wiring connections. If the wiring is correct, check Site ID. If it is correct, it means either the <br /> Transmitter is bad or there is a problem with the sensor, disconnect the battery cable from the battery pack <br /> and continue to Step 1 with the next Transmitter. <br /> 4. After verifying that each Transmitter is being received at the TLS RF(s), go around to each Transmitter; <br /> reconnect the Transmitters' battery cable to the battery pack. Replace dispenser's cover as appropriate. Go to <br /> the TLS console and configure all site sensors. Check for any comm alarms. If none are observed, the startup <br /> is complete. <br /> NOTE: If some Transmitters are not being received at the TLS RF, relocating the Receiver and/or the Repeater may <br /> improve reception. <br /> Initial TLS Console Setup Procedure <br /> QCAUTION! Failure to follow your applicable startup procedure will result in the probes/sensors not <br /> being recognized. <br /> • Sites with a New TLS-450/,TLS4 or TLS-XB Only <br /> 1. Power up all wireless devices. <br /> 2. Power up the TLS RF console and wait about 5 minutes. <br /> 3. Power up the TLS-450 console and wait 5 minutes until the device 'Discover Mode' is Complete. <br /> • Sites with all Other TLS Consoles <br /> 1. Power up all wireless devices <br /> 2. Power up both the TLS and TLS RF consoles. <br /> 10-37 <br /> GARB Approved 10M 10-Veeder Root TLS RF Wireless Systems(W2)-Executive Order VR-202 <br />