Laserfiche WebLink
Dispenser Interface Module FAwMODEM COMM? ETHERNET USB <br /> The Dispenser Interface Module (DIM) is a device attached to 0 <br /> the Power Supply Module. Connections to the DIM are located F-1❑ <br /> on the bottom left side of the Console using the appropriate <br /> cable kit based on the dispenser type. <br /> BUS EXT COMM2 LLDI/RS-485 <br /> L)CO Co W D n W D <br /> Z�Cn N Z <br /> DIM related ports 5 <br /> 0= RS422/232 Current Loop <br /> Ulla a Volume Input 9 p <br /> The console can gather ullage volume from either the internal <br /> inventory probes or from existing inventory probes through an External ATG. <br /> Using Internal Magnetostrictive Probes <br /> To use internal magnetostrictive probes, you must have Fuel Management System (FMS) enabled in the registration. <br /> See the TS-5xxx Programming Manual for instructions for programming the FMS section. The FMS section must be <br /> programmed before the VRM section. <br /> Using an External ATG <br /> There are certain requirements in order to retrieve ullage volume from an external ATG. <br /> •Continuous access to a RS-232 connection <br /> -Ability to respond to the following serial Command: <br /> Command: 1201 TT- In-Tank Inventory Report, TLS-350 command set <br /> Command: 10T—Inventory Report, TLS-250 command set <br /> • Serial Cable with the following specifications: <br /> Cable must be a `Null' Serial <br /> D139 Male (INCON Console)to either DB25 Male or DB9 Male (ATG) <br /> Use the following steps to connect an External ATG to a Console: <br /> 1. Connect the DB9 female end of the cable to Comm 2 on the Console. <br /> 2. Connect the other end of the cable to the serial port of the External ATG. <br /> 3. Set the serial port parameters to match between the Console and the External ATG, see TS-5xxx Setup Programming <br /> Guide. <br /> 4. Validate there is no"External ATG Communication" alarm. <br /> Remote ATG with TLS-250 or 350 Command Support Tank Sentinel Console(All Models) <br /> D <br /> RS-232 <br /> Note: A DB25 to D139 Null Serial Cable may be purchased from INCON, PN 600-0099. See the TS-5xxx Series <br /> Installation Manual"Communication Ports" section for pinouts of Comm Port 2. <br /> 11-11 <br /> CARB Approved IOM 11-INCON Vapor Recovery Monitoring(VRM)-Executive Order VR-202 <br />