COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

SAFETY DATA SHEET LKW1268 v9.2 AXALTA en/US Suitable extinguishing media Water spray,Dry chemical,Foam Extinguishing media which shall not be used for safety reasons High volume water jet Hazardous combustion products CO,CO2,smoke,and oxides of any heavy metals that are reported in"Composition,Information on Ingredients"section. Fire and Explosion Hazards Avoid heating above flash point. Special Protective Equipment and Fire Fighting Procedures Full protective flameproof clothing should be worn as appropriate.Wear self-contained breathing apparatus for firefighting if necessary. In the event of fire,cool tanks with water spray. Do not allow run-off from fire fighting to enter public sewer systems or public waterways. 6. Accidental release measures Procedures for cleaning up spills or leaks Ventilate area. If heated above the flashpoint,remove sources of ignition. Prevent skin and eye contact and breathing of vapor.Wear a properly fitted air-purifying respirator with organic vapor cartridges(NIOSH approved TC-23C),eye protection,gloves and protective clothing. Confine,remove with inert absorbent,and dispose of properly. Environmental precautions Do not let product enter drains. Notify the respective authorities in accordance with local law in the case of contamination of rivers, lakes or waste water systems. 7. Handling and storage Precautions for safe handling Observe label precautions.Close container after each use. If heated above its flash point,this must be handled as if it were a flammable liquid. Do not transfer contents to bottles or unlabeled containers.Wash thoroughly after handling and before eating or smoking. Do not freeze. If material is a coating:do not sand,flame cut,braze or weld dry coating without a NIOSH approved air purifying respirator with particulate filters or appropriate ventilation,and gloves.Combustible dust clouds may be created where operations produce fine material(dust).Avoid formation of significant deposits of material as they may become airborne and form combustible dust clouds.Build up of fine material should be cleaned using gentle sweeping or vacuuming in accordance with best practices. Cleaning methods(e.g. compressed air)which can generate potentially combustible dust clouds should not be used. Advice on protection against fire and explosion Solvent vapours are heavier than air and may spread along floors.Vapors may form explosive mixtures with air and will burn when an ignition source is present. Always keep in containers of same material as the original one. Never use pressure to empty container: container is not a pressure vessel. The accumulation of contaminated rags may result in spontaneous combustion, Good housekeeping standards and regular safe removal of waste materials will minimize the risks of spontaneous combustion and other fire hazards. Storage Requirements for storage areas and containers Observe label precautions. Store in a dry,well ventilated place away from sources of heat,ignition and direct sunlight. No smoking. Prevent unauthorized access.Containers which are opened must be carefully resealed and kept upright to prevent leakage. Advice an common storage Store separately from oxidizing agents and strongly alkaline and strongly acidic materials. OSHA/NFPA Storage Classification: IIIB Q 2019 Axalta Coating Systems,L. G and all affiliates.All rights reserved. 3.9 Copies may be made only for those using Axalta Coating Systems products. 2019-04-24 N 3