COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

SAFETY DATA SHEET LKW1268 v9.2 AXALTA en/US 8. Exposure controls/personal protection Engineering controls and work practices Provide adequate ventilation.This should be achieved by a good general extraction and-if practically feasible-by the use of a local exhaust ventilation.if these are not sufficient to maintain concentrations of particulates and solvent vapour below the OEL,suitable respiratory protection must be worn. National occupational exposure limits CAS-No. Chemical name Source Time Type Value Nate 1317-65-3 Limestone(calcium carbonate) ACGIH B hr TWA 10 mg m3 OSHA B hr TWA 15 mg/m3 Tota]Dust OSHA 8 hr TWA 5 mg/m3 Respirable Dust 13463-67-7 Titanium dioxide OSHA 8 hr TWA 15 mg/m3 Total Dust 14808-60-7 Quartz-crystalline silica OSHA 8 hr TWA 0.3 mg/m3 Total Dust OSHA 8 hr TWA 50 ug/m3 Respirable Dust Glossary CEIL Ceiling exposure limit STEL Short term exposure limit TL Threshold limits TLV Threshold Limit Value TWA Time weighted average TWAE Time-Weighted Average Protective equipment Personal protective equipment should be worn to prevent contact with eyes,skin or clothing. Respiratory protection Do not breathe vapors or mists. Wear an appropriate,properly fitted NIOSH approved respirator during application and until all vapors and spray mists are exhausted unless air monitoring demonstrates vapor/mist levels are below applicable limits. If respirators are required,use a properly fitted air-purifying respirator with organic vapor cartridges(NIOSH approved TC-23C)and particulate filter(NIOSH TC-84A).In confined spaces,or in situations where continuous spray operations are typical,or if proper air-purifying respirator fit is not possible,wear a positive pressure,supplied-air respirator(NIOSH TC-19C).In all cases,follow respirator manufacturer's directions for respirator use.' Eye protection Desirable in all industrial situations. Goggles are preferred to prevent eye irritation. ]I safety glasses are substituted,include splash guard or side shields. Skin and body protection Choose skin and body protection as appropriate for the concentration and quantity of hazardous substances,and to the specific work-place practices. Hygiene measures Wash skin thoroughly with soap and water or use recognized skin cleanser. Do NOT use solvents or thinners. Environmental exposure controls Do not let product enter drains. For ecological information,refer to Ecological Information Section 12. 9. Physical and chemical properties Appearance Form: liquid Colour:white ©2019 Axatta Coating Systems,LLC and all affillates.All rights reserved. 4-9 Copies may be made only for those using Axalla Coating Systems products. 2019-04-24 w 3 3