REMOVAL_2021 - Laserfiche WebLink

Home Browse Search

Safe Work Plan — JSA r Shell Stockton Terminal Job Tasks Outlined in Exhibit A - Shell Scope of Work Rev . A dated 7/22/2019 Scope of Work : Abandon existing contact water tank UG-5 in place • Triple clean tank • Have marine chemist verify the tank is clean • After confirmation the tank is clean then fill the tank with flowable fill slurry ( low strength lean concrete ) There are no expected Simultaneous Operations ( SIMOPS ) occuring in the vicinity of this work zone . SECTION 3 * SAFETY PROCEDURESAND POLICIES RequirementsGeneral The Foreman will be responsible for ensuring : 2 . All approved permits are displayed on the job site and requirements are adhered to as appropriate . 3 . Daily Tailgate meetings address all expected job site hazards by reviewing JSAs, confirm fitness for duty, and reinforce the support for Stop Work Authority . 4 . Verify all site workers are experienced and have appropriate training (API , Shell PI / PH , and Terminal training ) 5 . Verify length of service for each crew worker and implement the SSE program if any are present . 6 . Verify shaded break area and discuss breaks . .fecs-onad Protective . �, • . . PPE will be provided to work crew at no cost to them . Basic PPE for this work scope consists of: Level D — Hard hat, steel -toed boots, approved eye protection , reflective traffic safety vest, and appropriate gloves when needed . It is not expected that respirators will be required . If hydrocarbon vapors are measured in the breathing zone, work will stop and a plan to eliminate the hazard will be implemented . The Foreman will ensure that all crew members have the necessary PPE prior to the start of work and will advise the crew to practice positive intervention . PPE will be inspected prior to use and replaced if needed . Foreman will coordinate the set up an exclusion zone using caution tape and barriers to keep unauthorized people out of the work area . All equipment not needed for the work scope should be parked outside the exclusion zone . The area around the work zone will be kept clear. Hoses and cords will be kept out of walkways and working surfaces . WASTE MANAGEMENT The task of tank cleaning will generate water mixed with gasoline . The waste mixture will be transferred directly into the vacuum truck during the cleaning operation . The waste mixture will be removed from the site at the end of the work day . SPILL CONTROL There is a potential for a liquid spill on site should a hose or fitting leak . Spill control material will be available . RequirementsFire Watch