SU0014240 - Laserfiche WebLink

Home Browse Search

e. ACCESS AND CIRCULATION: The following requirements apply antl shall be shown on the Si[e Plan: 1. Access driveways shall have a width of no less than 25 feet for two-way aisles and t 6 feet for one- way aisles, except that in no case shall driveways designated as fire tlepartment access be less than 20 feat wide.(Development Titles Section 9-t Ot 5.5[h][t]) f. LIGHTING: Lighting shall be provided and comply with the following: �. If the parking area is to be used at night, parking lot lighting shall be installetl. (Developm¢nt Title Section 9-1015.5[g]) 2. Any lighting shall be designed to confine direct rays to the premises. No spillover beyond the property lines shall be permitted except onto public thoroughfares, provided, however, that such light shall not cause a hazard[o motorists. (Development Titles Section 9-1015.5[g][4]) g. LANDSCAPING: landscaping shall be provided antl comply with [he following: 1. A minimum ten (t0) foot wide landscapetl strip, respecting the ultimate right-of-way width of Eleventh Street, shall be Installed across the frontage of the project site. The strip shall be continuous except where crossed by driveways and walkways. (Development Title Section 9- 1020.5) 2. This project will be required to comply with the Model Water Efficient Landscape Ordinance Requirement per California Coda of Regulations,Title 23, Division2,Chapter 2.7. h. SCREENING: All storage materials and related activities, including storage areas for trash, shall be screened so as not to be visible from adjacent properties and public rights-of-way. Screening shall ba six (6)to eight(8)fact in height. (Development Title Section 9-1022.4[e][2][A]) i. SIGNS:Sign details shall be consistent with Chapter 9-171 O of the Development Titles and be included on the Si[e Plan. All portions of any sign shall be set back a minimum of 5 feet from any future ri9ht- of-way line,including any corner cut-off(snipe). (Development Title Section 9-1710.2[g]) j. BUILDING CODE:Ther following California 6uiltling Cotler(CBC) and San Joaquin County Ordinance requirements will be appilcabie to the propos¢d project.Ther following conditions shall be atldressed prior to submittal of a building permit application to the Building Inspection Division: t. A building permit for each separate structure or builtling is required. Submit plans, Specifications and supporting calculations,prepared by a Registered Design Professional(architect or engineer) for each structure or building, showing compliance with The 2019 California Building, Existing Building,Mechanical, Plumbing,Electrical,Energy and Flre codes as may ba applicable. Plans for the different buildings or struMur¢s may be combin¢d into a single set of construction documents. 2. A grading permit will be required for this project. Submit plans and grading calculations, including a statement of the estimated quantities of excavation and till, prepared by a Registered Design Professional. The grading plan shall show the existing grade and finished grade in contour intervals of sufficient clarity to indicate the nature and extent of iha worK antl show in detail that it complies with the requirements of the coda.Ther plans shall show the existing grade on adjoining properties in sufficient detail[o identify how gratle changes will conform to the requirements of the code. 3. The required plans must be complete at the time of submittal for a building permit Plans must address building design and construction, fire and life safety requirements,acc¢ssibility and show compliance with the current California codes and San Joaquin County ordinances.A complete sat PA-2100114—Contli[ions of Approval 2