WORK PLANS - Laserfiche WebLink

Home Browse Search

SOUND & COMMUNICATION SYSTEMS Section 16700 15-1207 characteristics, appearance standards, space requirements and field service staffing levels required to comply with the requirements of the specification. B. Other manufacturers systems and suppliers may be acceptable, but shall be approved for bidding, prior to bidding, by submitting all product data for review to the Architect/Engineer. Other manufacturers who have not been identified in the final addendum as acceptable for bidding shall not be approved. C. Bidders wishing to submit alternate equipment shall submit to the Architect/Engineer, at least (10) days prior to the bid opening, complete documentation describing the proposed equivalent system. This submittal shall contain all the following pertinent information: 1. Manufacturer's specification sheets and literature for each alternate item. 2. A written submittal outlining any variances the proposed alternate system would have from the specified system. All variances shall be referenced by page, paragraph and line of the specification. 3. Valid low voltage contractor's license. 4. Proof from manufacturer that contractor is an authorized distributor/installer for the system being proposed, with full warranty privileges. D. The Owner and the specifying Engineer will make the final review of alternate systems. Submittals failing to meet or exceed the specified requirements shall be rejected. No substitutions will be considered after the Contract award. PART 2 — PRODUCTS 2.1 SYSTEM DESCRIPTION A. Components of the IP Intercom System shall provide a complete system IP Based solution for a fully functioning Intercom System (IC) and Public Address System (PAS) for the project. System shall include software from a single manufacturer for complete control and monitoring of the system for a fully supported system. System shall be IP based and operate over a separate school Local Area Network (LAN) and Wide Area Network (WAN). B. Contractor shall provide all system programming for configuration and interfaces. C. System shall be capable of being configured and controlled remotely via Owner provided connectivity (e.g. via a smart phone, VPN, etc.). D. System shall include General Purpose Input and Output (GPIO) trigger points for interfacing to other systems including Emergency and Security Systems, to provide event driven configuration scenarios for the system. E. Each classroom shall be a "zone" on the system capable of individual intercom use or as part of a "zone group" or "all call" during Public Address System use. Classroom end device shall be a PoE device attached to the school network. F. Common areas, including but not limited to, Corridors, Commons (cafeteria), Gymnasium, Media Center, Mechanical Rooms, and Restrooms, shall be provided with PAS coverage from the system for general and emergency announcements. G. System shall provide multicast or hybrid unicast/multicast for configuration of LAN and WAN with standard Ethernet protocols. No exceptions. H. System shall interface with any telephone system utilizing either SIP, FXS or FXO Port type integration thus allowing the school(s) to upgrade or replace their telephone system without 3