WORK PLANS - Laserfiche WebLink

Home Browse Search

FIRE ALARM SYSTEM Section 16710 15-1207 school activities and as approved by District. Contractor shall provide technicians to conduct all testing (from same firm preparing submittals and performing fire alarm work). Testing shall be coordinated to include the Project Inspector and a representative from Engineer's office. At time of testing, Contractor shall insure that his submittal will reflect all materials and work necessary to make new equipment function properly with existing. C. Detector locations shown on drawings are approximate only. Exact locations shall be coordinated with lighting and mechanical equipment and shall be placed in accordance with manufacturer's recommendations (with respect to supply air diffusers, etc.). D. Detectors, strobes, and horn/strobes (including minihorn/strobes) in student toilet rooms shall be provided with wire guards. E. Fire alarm circuits shall be terminated on screw terminals. Terminal blocks shall be Allen-Bradley Bulletin 1492 with 600 volt screw terminals for #22 to #10 conductors, mounted to type N22 channel, or approved equal. Submittal shall show internal elevation of terminal cabinets or backboards with equipment laid out. F. All cables entering terminal cabinet shall be identified with Brady or E -Z Code wire markers. Upon completion of installation, six (6) copies of one -line "as -built" wiring diagram shall be furnished to Architect. G. Each cable run on wiring diagram shall be identified with exact wire marker code (numerical or alphabetical) as appears in terminal cabinets. H. Station locations shall be identified by school's actual room numbers and system shall be programmed accordingly. Coordinate actual room numbers with District. Coordinate final programming with District. Contractor shall furnish a printed copy of final programming to District. End -of -line resistors shall be installed in terminal cabinets. Color code wiring for the system to match existing color coding scheme. K. No splices shall occur in underground pullboxes. Fire alarm system wiring shall be continuous, without splices, from terminal cabinet to signal cabinet and signal cabinet to devices. All interior pullboxes shall be accessible and locations shall be recorded on "As -Built" drawings. 3.02 CONSTRUCTION MEETINGS A. The Contractor shall schedule construction meetings at the jobsite as follows: 1. Pre -rough -in meeting shall occur before installation of any boxes, raceways, etc. Exact locations of all detectors and strobes shall be established as recommended by Fire Alarm System subcontractor. 2. Pre -wire meeting shall occur after raceways are installed and prior to pulling of any wire or cable. 3. Pre -termination meeting shall occur after wire and cable has been installed and prior to 5