WORK PLANS - Laserfiche WebLink

Home Browse Search

FIRE ALARM SYSTEM Section 16710 15-1207 termination. B. Meetings shall be scheduled by the Contractor on a building by building basis and shall include the Project Inspector, School's Representative, the electrical subcontractor, and the Fire Alarm System subcontractor as a minimum. 3.03 TESTS A. One-half to three-quarters of the way through project, District Facilities will set up a meeting (preferably at the school site) with decision makers from Facilities, Police Services, Maintenance, Maintenance Alarm Tech, General Contractor, Alarm Sub -contractor, and School Administrator to review the alarm protocol and to identify responsible personnel and timelines for the items listed in paragraph D, which follows. B. After all equipment specified herein has been installed and is in operating condition, performance tests shall be conducted by Contractor in accordance with, but not limited to, Table 14.4.2.2, NFPA 72 to verify that installation and components comply with these specifications. Contractor shall furnish competent personnel for these tests. Testing shall be scheduled with the Owner and shall occur after receipt by Architect of Contractor's written certification of completion, record one -line diagram, wiring diagrams, maintenance and operation manuals, and other "As -Built" data required by these specifications. C. Upon completion of the installation of the fire protective signaling equipment and after satisfactory performance tests have been conducted, a satisfactory demonstration of the entire system shall be made in the presence of the Project Inspector. Contractor shall coordinate with Project Inspector and School. Demonstration shall be completed prior to occupancy by School and prior to final testing with the Owner. D. After system is completely tested, the Contractor shall take the following actions with the Owner: 1. The Contractor will schedule a meeting with the Alarm Sub -contractors and Owner's Representatives to determine alarm zone and device nomenclature. The Contractor shall insure that the alarm zone and device nomenclature matches the actual building and room numbers used by the school. Architectural numbering shall not be used. Once confirmed, the Contractor shall demonstrate this to Owner's Representatives. 3.04 FIRE ALARM SYSTEM CERTIFICATION A. Fire Alarm System Certification: Written certification on the form found in Figure 10.18.2.1.1, NFPA 72 shall be submitted by the Contractor to Project Inspector stating for himself and the equipment manufacturer that component parts are as LISTED AND APPROVED BY State Fire Marshal, that the installation conforms in all respects to requirements as set forth in the California Electrical Code, that acceptance testing has been performed in the presence of the Project Inspector. Contractor shall complete and sign form and submit to Project Inspector. END OF SECTION C.